Search the Community
Showing results for tags 'won’t'.
Found 1 result
-
It all started innocently enough. The aluminum crank case covers look bad, so I removed them to polish them up, while I was at sea. I removed the water pump cover, clutch cover, plus the small rear one on the left side (transmission?). I couldn’t get the large front one (stator?) off at the time. While I was waiting for the gaskets to come in, I worked on the large cover. When I finally removed it a small gear fell out. I was able to put it back, hope it isn’t supposed to be in a certain way. I went to remove the screws holding the wires to the cover but no luck. I have the right size screwdriver, but they won’t move. I stopped before I stripped the heads, but I think it won’t take much force before they are striped. What is the easiest way to get these screws out? I can’t get the cover to my workbench, as it is still attached to the bike by the wires. It is free to move around as I try to break the screws free. I tried hammering on the screwdriver while twisting, but was getting nowhere. Help I don't know where to go from here. Bill
