Search the Community
Showing results for tags 'troubleshooting'.
Found 4 results
-
I've been troubleshooting a Cruise control on an '06 Venture that I purchased used last October. The cruise has not worked at all for me. I followed the self diagnostic procedure in the service manual. Did the set anf res buttons 6 times, the lights blink correctly, but then only the res light stays on. Checked the brake switches, they're ok. Did the throttle test, but did not hear the vacuum pump come on. Hot wired the vacuum pump and it runs and draws vacuum. Did the cruise relay test and it passed. I'm left with checking the speed sensor (assume if the speedometer works, then the sensor works; may be a mistake), or replacing the cruise module. Has anyone had a similar experience, or got any advice? How much would a replacement cruise module cost? Your thoughts are appreciated. Frustrated in Ohio:confused07: -
Last night I had the VR idling (fast- 2000) for about 20 minutes while I fiddled with the headlight alignment and it boiled over. It has idled for longer than that in the past without boiling. The outside temp was about 66F so was probably not a factor. Could not hear the fan going so that is likely the cause of the problem. Did not find anything in the Tech Library and the search will not accept fan as a keyword so anything in particular I should know about troubleshooting this issue?
-
I have a fan over ride switch but lately my fan seems to work only when IT decides to. Usually only when cold, not when I need it to work. Fan failures haven't been brought up here but figured I'd ask before troubleshooting the wiring. -
DonB posted a great diagram on troubleshooting the ignition system. http://www.venturerider.org/forum/showthread.php?t=15135 He lists the specs for an '85. Are these the same specs for an '89? Thanks...
