Search the Community
Showing results for tags 'randomly'.
-
I've reviewed the headlight posts and can't seem to find a solution to my problem. I have an idea what it is. The headlight warning kicks on randomly, but the headlight remains lit. If I toggle the high beam/low beam, the light goes out for a little while. It was with just the high beam, and would go off when I switched to low beam. Now it will come on randomly on either low or high beam and will randomly go out (the warning, not the headlight). Flipping the headlight switch usually works temporarily. I'm wondering if it's an issue of Computer cold-soldering...or a bad headlight switch? Any ideas? Thanks.
-
I purchased the Baron's mini-bullet tach (BA-7573-00) with brake resivoir mount kit a couple weeks ago. This model has white LED backlighting only. The instructions were universal and pretty much pertained to HD intall. After e-mailing John and getting pertinant instructions (not found in the supplied paper work) I was on my way. There is a tech article here in VR on the installation, BUT there are a couple changes! The blue wire from the sigle fire ignition adaptor runs all the way to the rear coil's (either one) negative side. The black wire from the tach cannot be grounded to the coil bolt but another frame ground. After installation, the LED back light flickered randomly and the tach needle would fluctuate randomly. There seemed no correlation between the two. I regrounded the tach wire but no improvement. My next step will be to remove the red (tach power) and yellow (LED power) tach wires from the positive terminal of the front coil and connect to a switched 12V source. John's only other suggestion, if this failed, is to install a resistor. Any of you weekend mechanics or better yet a seasoned mechanic have any ideas? Within the last month I had a complete tune-up including carb sync.
-
my radio on 05 venture dont have sound i could see the cassett playing radio changes stations , cb channels do scroll but no sound before dying it would work randomly .i checked the speekers wires do not have any voltage. i would like some advise. Thanks