Search the Community
Showing results for tags 'lash'.
-
So to make a long story short I am instaling a different middle gear in my 88 venture, so I wanted to know when the back lash is to be checked in 4 different places should I have the very same back lash # in all 4 places or can I be any where from the min to the max setting as given in the book, because it looks like there can be 2 shimes on one side and 1 on the other, And if I was to use that blue dye to check my work would that work on the way the venture is set up Thanks.
-
Ok gang, I have a question and this is the place to get lots of opinions! I have installed Vmax cams and springs in my 1987 Venture 1300 engine. Venture intake valve lash is the same as the Vmax. However, exhaust valve lash is different; Venture: .16 - .20 mm Vmax: .26 - .30 mm Which lash will be right for my Frankenstein?