Search the Community
Showing results for tags 'lamp'.
-
Ok So it was not a riding day yesterday so I decided To Adjust my Passing Lights. I had one adjusted last night and and gave up on the second. I went back at the second this AM and got it close enough and when I went to Secure everything.....nothing....no lights! After removing the fairing I chec...
-
Passing Light hollow bolt
iquester posted a topic in Royal Star and Royal Star Tour Deluxe Tech Talk
Yep. First drop of my 97 Royal Star. Cager pulled out in front of me at a 4-way stop just as I started. I stopped (thank God) in time but dumped the Bike over as I avoided her. No real damage except to my pride and the right side passing lamp and turn signal. Have the replacement lamp and signal loc... -
So I would like to get some passing lamps and I like the tri-bar halogen ones. I inquired about one set with part number STR-4WM35-10-EA and was told they were the lamps only with out the Buckets? Another set with this part number I inquired about says there is no harness, just a wire coming out of... -
Anyone install the passing lamp bar spacer ( the one Tony makes) on a lowered front end 2nd gen? are there any issues with it hitting the fender? Thanks
-
...on one side. As far as I can tell, these are the original Yamaha passing lamps. Is there another sealed beam that will work or must I buy the original Yamaha lamp?
-
http://www.venturerider.org/forum/attachment.php?attachmentid=56600&stc=1&d=1305504455 I just purchased a 2008 RSV and judging by the angle of the lower wind deflectors, relative to the fork angle, I question whether or not I have the right passing lamp mount. Could it be that this mount is for a...
-
Good afternoon everyone, Both hi and low beam on my 08 RSV went out last week. I have been reading the threads on this problem and have done the starter switch lube and fuse checking. I have read there might be a possibility of the Reserve Light Unit going bad but how often is this a problem? I'm...
-
Started to install the passing lamp light bar on my 05 RSTD and noticed that the Headlamp bucket has a bracket that attaches to the stock light bar but there isn't any means to support the HL bucket on the new light bar..... What am I missing..?? Thanks for your help. -
I would like to install one of those light blue head lamps on my 89 VR. Anyone knows what I should get?
-
I was coming home from work this evening and was making a slow left turn when my rear wheel slid out from under me and down I went. Luckily I was going real slow at the time and wasn't hurt. My bike a 96 Royal Star Tour Classic didn't get hurt to badly either. The crash bars did their job pretty wel...
-
I've not been satisfied with the Ajure passing lamp lens and I would like to go to a halogen housing. So I'm still wondering if the Vstar lamps will fit on the Venture light bar? The catalog says they are not for the Venture and I just wonder why they won't work. I know the switch is on the housing... -
We purchased a visor for the front headlamp on our 2005 Midnight Venture but I don't quite see how the assembly comes out of the fairing. I don't have a service manual yet and don't want to break anything. The passing lamp visors installed without problems but I can't get the headlamp to release and...
-
i've posted this request in the Watering Hole and considering my request is about RSTD i thought i would post here as well. i have an 07 midnight RSTD and was instalingl passing lamp mount bar part # STR-1D635-40-00 and found that i cannot fit my OEM flasher lamp onto the special bolt which is provi... -
I've read thru the posts and still need some direction. i have an 07 rstd i purchased the Yamaha passing lamps and bar. I've got everything apart and have difficulty trying to push the stock turn lamp onto the special bolt supplied with the kit. here are the measurements - the o.d. of the special bo...
-
I have my passing lamp dealer installed at the time I purchased the bike. I went for a ride last Monday and discovered that my passing lamp (both lights) are no longer working. I checked the fuse box on the left side of the bike and all fuses are ok. All other lights work, rear lights, and turn s...
-
Need help to tighten passing lamp
Yamaman posted a topic in Royal Star Venture Tech Talk ('99 - '13)
Ok what is the trick here? The passing lamp and turn signal on the right side has worked loose and I can't seem to figure out how to tighten it. It seems like I need to screw the passing lamp into the turn signal shaft, but it hits the fairing. Do I have to remove the whole assembly? And if that's t... -
Blowing off steam.... On my recent group ride to Arkansas, I started popping fuses on my passing lamps. I'd just rewired them recently to use a relay and direct connection to the battery, so I reckoned that's where the trouble lay. Then, on the last day, I lost my Gremlin Bell. Those suckers w...
-
Is the passing lamp spacer still available, and if so where and how much?
-
The 2002 Venture I am picking up this week has the sealed beam passing lights. The dealer tells me that I would have to buy the light kit (including housings) for $137 if I want to switch to halogens (35W, H3 lamp). He also quoted $22 each for replacement sealed beam bulbs in case I just want to rep...
-
Good Morning Everyone, I would like to replace my stock passing light bulbs with a brighter halogen lamp. However i'm not interested in increasing the amount of wattage draw on the system. My question is, what lamp would you recommend for this application? I would like a nice wide pattern not...
-
Hi! I'm new to this website and also a new owner of an '05 RSV which I'm rebuilding from a salvage bike. I'm down to the last part - passing lamps. I saved the original passing lamp bar and turn signals hoping I could find another damaged one and swap out the parts. I did find an '07 passing lamp/ba... -
Received my Passing lamp set up today and there no instructions or parts breakdown. I think I might have the wrong bolt that mounts the lamp to the light bar both parts are factory Yamaha. The Lamps are #STR-4XY35-10-00 No bolts were supplied with the lights and the box was not opened before I rece...
-
I purchased a mounting bar and passing lamp off of E-bay for my 08 RSV. Either I have over looked the instructions or they didn't send any. I am an electrician so the electrical part is no problem. I'm looking for the mechainical instructions. I've searched for a thread with mechanical instructions...
-
Turn Signal/Passing Lamp problem
Bluesman posted a topic in Royal Star Venture Tech Talk ('99 - '13)
I'm in the middle of installing my factory passing lamp mount and ran into a snag. I've just attached the passing lamps themselves to the mount and now I'm in the process of attaching the turn signals, problem is, I can't make the connection because of the rubber sleeve. Is this supposed to be rem... -
Hey Everyone.... I have looked and looked on the site and have not found anything about the following I got from the Star Touring Remedy List... Do NOT buy the Venture passing lamps. Instead, buy the V-Star halogen passing lamps. They will fit the Venture passing lamp mounts with no problem. R...
