Search the Community
Showing results for tags 'kents'.
Found 1 result
-
Here is Kent Hartland's DIY With my Version for Added Running Lights. He shows his version with the standard set-up . Follow his directions [ATTACH]41117[/ATTACH] Mark and drill a pilot hole on the second ring and across from the bolt stud. [ATTACH]41118[/ATTACH] I went up to a half inch drill bit and finished with my Dremal sanding tool. All my drilling was done form the inside as well. Another thing that is different is place the plastic nut that you just cut REVERSE IT from how Kent show's his. The reason is that it will clear the lens bolt tab perfect. finger tight. [ATTACH]41120[/ATTACH] I also used some clear silicon sealer and just placed a small ring around the butt of the light lens as shown. it will squish out a little and wipe right off with ease. [ATTACH]41127[/ATTACH][ATTACH]41119[/ATTACH] Here it is installed from the inside. [ATTACH]41121[/ATTACH] It is almost in the right spot to be able to notice if you forgot to turn off your blinkers. This one shows that it will be lined up with the blinker bulb. [ATTACH]41123[/ATTACH] And a few more all done , takes about an hour or less. I also added some di-electric grease to my bulbs, they were extremely dirty inside the bulb contact rings. [ATTACH]41122[/ATTACH][ATTACH]41124[/ATTACH][ATTACH]41125[/ATTACH][ATTACH]41126[/ATTACH] Kent's picture was a little blurry, so here is one that might be a little better to read the part number. [ATTACH]41129[/ATTACH] Enjoy, Jeff
.thumb.jpg.176b2ebbe9863175975d94710375c414.jpg)