Search the Community
Showing results for tags 'indicators'.
Found 4 results
-
Ok,here is my CMS mod. Due to failed tail light I tracked problem to the CMS and decided to complete the mod I had been planning to do... I kept all high,low,tail,brake current running thru the CMS per stock(had considered bypassing wiring external CMS but trying to not modify stock wiring),but wanted to keep the fail indicators working, but change to LED lighting that would cause fail indicators to turn on. So instead of the fail indicators being activated by the reed switches-I extended the reed switch wiring external the CMS for external input 1st pic the corrosion causing my tail light problem First removed all 4 coils and reed switches second drilled oversize holes for 14ga solid copper wire where the coils were third installed 24ga solid telco wire in place of the reed switches then I mounted canabilized RJ11 phone jack to rear cover of CMS, and connected telco wire to RJ11 with screws mounted on rear side of CMS cover 2nd pic schematic of CMS input circuits for these 4 items and modification next 4 pics removed coils and drilled holes next 2 pics RJ11 jack install last pic I sealed board with finger nail polish to prevent future corrosion Simple phone extension cord plugged into RJ11 brings wiring where needed for future direct light monitoring, and allows easy disconnect for future dash removal Now I need to apply a frame ground to keep the warning lights off- easy to build future circuit to open frame ground during a failure of direct light monitoring circuit of hi,low,tail,brake. I also replaced all dash indicators with LEDs from superbrightleds.com found I had to reinstall 1 158 back into reserve light warning, due to small current always on lights up LED full. I put in blue back lights, and white warning lights. Only problem is Green neutral looks blue. Would suggest green LED here. All tested and works as advertised.
-
10,000 miles and I get a noise like a rock is caught but I don't believe that's the issue. Need to take the calipers off and have a look. Would the pads be worn out already? They have indicators for wear? As an aside, we did a beautiful overniter into Kalispell MT thru Eureka. What a gorgeous couple days here!
-
I saw a Venture in Forestburg TX awhile back that had replaced both stock mirrors with a style that had LED turn signal indicators in them. Anyone know where to get these? -
I was wondering if anyone has a list of the bulbs used in the indicators and illumination for the dash on the 83 venture. I am looking at opening it up to replace a couple of dead dash lights and might as well replace them all while i am in there.
