Search the Community
Showing results for tags 'harbor freight'.
-
So I successfully installed an el cheapo tach from Harbor Freight. Basically I used the cheapie as an excuse to create a wire harness for a nicer tach in the future. I used the yellow wire from the right rear coil as suggested by coop for the trigger and ran the other wires into a length of 3/8" split flex tubing, under the tank, up to the triple trees where I'll be installing a 4-5 pin plug. For now it's hard wired, but you get the idea. The tach works "perfectly", smooth sweep and very responsive. The yellow wire was an excellent choice, thanks coop! My question is, does my bike idle at 400RPM? I thought I read somewhere they idle around 1000ish. Or no? The rev limiter is set around 6000RPM but on this tach, to me, 2000RPM is painful...I almost never push that hard before a shift.. I think it reads low...confirm? https://www.youtube.com/watch?v=m4MMoKy6I3Y
- 17 replies
-
- harbor freight
- idle
-
(and 2 more)
Tagged with:
-
I recently bought a trailer from harbor freight for a trip this summer out west before I pack up for the trip I planning I draggin it around home a lot any advice on max weight, tire psi, suspension psi, safe speed, anything I should watch for as far as harbor freight quality "bearings, balanced tires" etc. Also I haven't tore off the stock lights and put my L.E.D.'s on yet, am I ok to run the standard lights as far as the staters go?
- 15 replies
-
- advice
- harbor freight
-
(and 3 more)
Tagged with: