Search the Community
Showing results for tags 'fin'.
-
What is the the threaded hole behind the front left fin cyclinder cover. I noticed a little bit of antifreeze pooling around that area and i just wanted to know what is was. I may have just dropped a little splash of it. But would still like to know what that is there. The back side of the fake find has a solid little circle piece that goes over it.
-
Best thing since sliced bread. Took longer to installed the bleeders then to do the job. Here are a couple pics of how bad my master clutch looked like. Ended up having to use paper towels and Q-tips to clean the sludge out of there. the speed bleeders made this so easy to do. It also helps if your remove the number one cyl fin to replace the bleeder. Last change was seven years ago. (way to long) With the speed bleeders I will change once a year from now on. [ATTACH]72443[/ATTACH] [ATTACH]72444[/ATTACH] [ATTACH]72445[/ATTACH] [ATTACH]72446[/ATTACH] [ATTACH]72447[/ATTACH] [ATTACH]72448[/ATTACH]
-
I'm about ready to start swapping out the fin covers for a set of blacks, and after reading about coolant leaks coming from under the covers I thought I'd go ahead and do a little PM and order new gaskets. After looking at the parts schematic I'm confused. It shows something called a Damper Engine Mount. #37 and #40. And they sure don't look like a seal to me. Are these things rubber, and do they seal anything??
-
I would like to replace my original antennas by a new one. Especially for AM-FM and for a Sirius (satellite) . If one of you had installed a (shark fin antenna), I will really appreciate to receive your feed back and the specification of your new antenna. I live in a region where the signal is very poor. Thank you for your reply !