Search the Community
Showing results for tags 'dremel'.
Found 4 results
-
Hoping someone can help. I have a 98 RSTC with 4 into 4 pipes. I thought the dremel trick (where you cut the pipe a few inches into the back pipe) would work but the diameter of the the 4 into 4 must be smaller than the 4 into 2 because the dremel cutting disc is too large! What other mode can I do? I only want a moderate noise increase. It it would be good if someone could also recommend suitable aftermarket pipes for 4 into 4. -
http://www.northerntool.com/shop/tools/product_200326924_200326924 As I needed some accessories for my Dremel for my fork polishing project I came across this at Northern Tool. Since I was already in possession of a NT 50 dollar gift card it only cost me 10 bucks!! The same stuff with the Dremel kit would cost well over 100 bucks! At 59 bucks its quite a steal. If your into any type of hobby stuff this tool is a great addition for the price.
-
I finally bought a dremel kit, mainly to fix a few broken tabs on the fairing but I'm sure it will be very useful for other things too. What's up with the drum sander bit? There is a rubberish drum on an armature and some sanding tubes that apparently slide on the drum. There is nothing I can see that will hold the tubes in place and even light pressure makes them slide up or down. Obvious or not, what am I missing?
-
I have seen where some were asking about muffler for venture that sound good but not loud. The yamaha shop gave me at set off of a 2007 tour deluxe. has the same the part number as the ones on my 2000, except they have moveable tips. I used a dremel tools with a cut off disk, went up in the muffler 1 inch and cut the tube, pushed it to the side and put them back on, they sound great, but are not loud unless under full throttle. also you can't tell the mod has been done looking at the muffler, nor can you run the stick up into muffler to check the baffle. This can be done to any 99 up venture, it was easy to due only takes about an hour. You do need the extension set for the dremel tool. Gregg:big-grin-emoticon:
