Search the Community
Showing results for tags 'cruse'.
-
hello all my 99 rsv started to run bad today it acts like it is running out of fuel i have the a/m fuel pump i replaced the fuel filter last week. what it is doing when i cruse at 55 or 60 it acts like i am running out of fuel i hit the throdel and it takes off and runs fine them at cruse speed starts missing again like needs fuel any idea what to look at thanks bumble bee
-
When I got the 01 the guy I got it from said the cruse was a little intermittent, and it was. It would hold some now and then some times for five or so minutes, and other times up to 45 or so. Didn't think too much about it cause I was going to Trike it soon. After Triking I rode it foe a few hundred miles before taking it apart again to paint, but at about 300 or so miles the speed -o went nuts, all over the dash, and I thought that the sensor got knocked out of whack underneath. I couldn't do any thing until I got the parts back to run it and check it out. I readjusted the sensor, and now have a steady needle, but the cruse upper two lights flash 4 times, and then off, with no set like before. I know that there are several things to check, but what I am really asking to get started is. Is the sensor a good or bad, go-no go device or can they be intermittent AKA Flaky. I know that until I get a rock solid speed the cruse isn't going to do diddly. Any ideas...
-
I may have read something on here somewhere about starting an 88 venture in gear. Are you suppose to be able to start one of these bikes in gear with clutch out. I am going to work on my cruse this weekend and I know somebody said something about a clutch switch. :think:
-
I went to set the cruse control today and it did not work. I made sure the switch was on but nothing. I turned it "the switch" off. I don't think I have ever had it in the off position because it really sticks out in off. Any way, I turned it back on and the lights came on for a second than back off. Did the same over and over. The last time I did it I left it off for a mile or so. Turned it back on and this time all is working. Go figure, maybe the switch went bad or is going bad?