Search the Community
Showing results for tags 'coil'.
-
Long trike day last week; drove to KY to visit Hannigan factory. Drove through storm front that should have been short; lasted through entire state of TN. 3\4 of the way through trike started misfiring, running porly, and lost acceleration. I am assuming that water got through either plug wires or i...
-
Can anyone tell me which wire coming rom the TCI module goes to which coil? I have determined that number one cylinder is the left rear, number two is left front, number three is right rear and four is right front. Now, there are four wires coming out of the TCI- Orange, Grey, Yellow and White that... -
Please oh great and wise ones... I'm going nuts here. About two months ago now I got stranded at work on my 99RSV. Rode to work just fine. When I went out to start it to go home, the starter turned and turned but she wouldn't start. I pulled the two back plug wires (cuz I could reach 'em) and stu... -
Im appealing to the wisdom of this site to find a mistery. Well here goes. I'm not getting a spark on second cylinder. I've gone thru the diagnose on the clymer's manual and all indicates is the igniter unit. I've changed it twice and same. I've switched the wires from the front primary coil... -
Hi, I have been having issues with a poor running 89 that is very sluggish. acts likeit is on 3 cylinders much of the time. I have rebuilt the carbs, synced them with a tool, and installed new plug wires, caps and plugs, checked the pickup connectors, and cleaned up the TCI connectors. All cylind...
-
:sick:hay I gess I will just jump in and ask you if anyone can help me out I have got a 87 1300 with a dead # 2 cylender no fire I thought it was a dead coil but I took the # 4 electrical conector and hooked it to the # 2 connecter and I got fire from the coil so I don't know if it is the brain or t...
-
I am considering a diaphragm to coil spring conversion to try to minimize slippage during hard acceleration. Before I do, I would like to get some feedback from anyone who has done it. Was it worth it. I don't want to do something I will just regret later. Why did Yamaha change to the diaphragm clut...
-
Going to try this again. Anybody have an old , bad, removed, ignition coil from a 2nd gen laying around ?? If you replaced a coil, could you pull the plug wire out of the " old " ignition coil, and take a photo, or let me know, if the plug wire can be " Re-Installed " after you pull out the...
-
Ok, we all know that on 1st Gen coils, you can eaisly remove the plug wire from the coil, and the spark plug cap. On the 2nd gen coils. the plug wire appears to " NOT " be removable, ( or replaceable ) from the coil end, of the plug wire. SO-- I was looking at my right front Ignition Coil on...
-
Greetings, I am at an end. I do not know what is wrong with my motorcycle. I have a 2006 RSTD with 8500 miles, and a few months ago I noticed a little backfiring when riding (mainly coming out of the right muffler.) It progressively got worse. I decided to change the plugs and noticed that the re...
-
Before my long trip i have accumulated some spare parts to take with me. I am taking TCI, rectifier/regulator and ignition coil (I am taking just 1 spare of the 4 that i have). Is there a way to test the regulator and ignition coil without putting it on the bike? I have already cheched the TCI on... -
Before my long trip i have accumulated some spare parts to take with me. I am taking TCI, rectifier/regulator and ignition coil (i am taking just 1 of the 4 spares that i have). Is there a way to test the regulator and ignition coil without putting it on the bike? I have already cheched the TCI on t...
-
Well I have finally finished my Bench Tester for TCI's. I can now take in anyone's TCI to test and give a report on the results. The test will consist of the following. 1. Test each input coil circuit to see that it activates the corresponding ignition coil output transistor in the TC...
-
I swapped wires on the coil and still had a dead left cyl. Does anyone have any pointers on how to drop the rear cyl. coil packs so I can check the wiring. Is there a test that will tell if the ignitor is toast?
-
.thumb.jpg.9dfefb49018580a1813c8128f131546e.jpg)
is this what we (1st genners) have? a CDI system? anybody try these?http://store.prestoliteperformance.com/accel-mc/metric-motorcycle/universal-super-coils-black.html. -
Well figured I would post this here just to see if we have any out board Techs or folks familiar with this engine. Here's what I have got. 1995 Yamaha 225TXRT. Carbureted (6 individual) 76 degree V6 First noticed the problem as a surge sensation running at 4000, would get an intermittent burst fo... -
I will start this post by saying, 'No Venture parts were harmed in the making of this post, however there was an unfortunate VMax casualty' Pictures attached are of a group of solenoids from a MKI, MKII Venture and VMax. 1st picture is of on left an MKII Venture, middle is I believe an 83 V...
-
I will start this post by saying, 'No Venture parts were harmed in the making of this post, however there was an unfortunate VMax casualty' Pictures attached are of a group of solenoids from a MKI, MKII Venture and VMax. 1st picture is of on left an MKII Venture, middle is I believe an 83 V...
-
For repairs. I've been dealing with bad gas milage for a couple years now. I've had everything fuel related checked, synced, cleaned etc. I've read about these coils going bad on occassion. Namely the number three coil. So this summer I bought a set of coils from a low milage crashed RSV for $4...
-
Last week, I replace a bad coil on my RSV. It was the right rear (number 3) coil. I was talking to a couple of other RSV owners today and they commented that everybody they know who has had to replace a coil it has been the number 3 coil. If you have replace a coil, which one was it that was ba... -
I have a 08 RSV and getting ready to install a Biker's Choice tach. It says the green wire goes to the negative terminal on the coil. Is there a coil diagram available to show me where the negative terminal is? Thanks -
The Problem... My 07 RSV ran good (not great) most days, until a 100 to 150 mile break/rest, after the 15 to 30 min. break the bike seemed sluggish and sometimes similar to a dead cylinder. Sometimes if the ride was early morning, a damp day or late evening, the problem seemed to self heal. Having...
-
After 5 months of on again off again tinkering, my 92 finally runs, not well, but it runs. Got the bike from an estate, as a basket case, last year and actually began work on the bike last July after I found a good drive shaft and differential. It had been torn apart in 2003 after the previous ow...
-
I have a set of Denso COP coils in hand. They came out of a 2007 Honda CBR 1000. This unit would replace the larger coils used on the bike now. 129700-4840 10484 printed on coil end - 08H31 stamped in same area The Ignitech TCI module maker said it would handle the coils lower primary resis... -
Picked the new bike up from the dealership on Thursday, on the ride home I thought it was running a bit on the lumpy side but put it down to not being run much since it was imported from the US. When I got home I checked the temperature coming from the header pipes and the rear left was a lot cooler...
