Search the Community
Showing results for tags 'caution'.
-
This warning about Locktite is posted here periodically, but since I just worked on a bike today with massive ABS plastic damage due to stupid Locktite use, I thought I'd start it again. The bottom line is that Locktite is known to damage many plastics, and ABS is one of them. We often caution people to never use Locktite on any screw that goes into plastic, but the problem is much worse than that. NEVER use it on anything that is even near ABS plastic! Every once in a while someone gets a bit uppity about these warnings and tries to say it is BS if a screw/bolt is going into metal, but I will give you first hand information about how much damage can be done by ignoring this warning. Had a guy come by today with 2nd gen trunk where all of the mounting points inside the lower trunk for the latching mechanism had busted loose. This just does not happen on this bike, so I was puzzled by why it had happened to him. The initial examination looked like maybe the plastic was defective from the factory. I have 100,000 miles on my RSV, most of which have been with the trunk over-full, and I have never had any problem, so why did his all break? Well, it became obvious while we were fixing it. Turned out that the plastic all around the latch mounting points had just disintegrated - no clean breaks at all, just crumbling plastic. And when I was removing the mounting bolts, I was struck by how tightly they were frozen into to the tinnerman nuts that fit over the plastic mounting tabs. These bolts should easily unscrew, but not his. Closer inspection showed that some poorly informed person had used Locktite on each of these bolts. Although these bolts do not directly screw into the ABS plastic, the tinnerman nuts clip over the plastic tabs so the bolts fit through a hole in the plastic, and the Locktite fumes damaged all of the plastic around the bolts. So the standard warning remains as strong as ever - NEVER use Locktite anywhere near ABS plastic! Goose
-
Caution !! ya`ll it is Summer or close to it, and the slithery creatures are out! This morning, while out in my " Shop" I pluged my big fan up, it blew the Ground fault breaker on the wall socket, so I go over and push the re-set, after pushing it, I see this 2ft long bundle of fun!!! I do not know how I didn`t get bit, as my hand was only about 2in from its head.. Ya`ll be careful!!
-
There have been several members that have been burned by a fellow member in the VR classified section. I am sure that 99% of the members of this forum are good, honest people. I hate to see the other 1% screw up a good thing. My question is...should I mention this individual's name so that others can use caution in their dealings with him? Or, should I keep my mouth shut and not flame fellow members? I wouldn't be so bothered by this, but some people have lost considerable amounts of money to this guy. Let me know what you all think.