Search the Community
Showing results for tags 'all-thread'.
Found 1 result
-
Just finished making "2" (TWO) Flag pole under $15.00 . Here's pictures of one of them mounted on my rear trunk rack . The mast are made of lavatory water supply (tubing) lines , the ones made of chrome plated brass . I used 3/8" all-thread inside the tubing to striffen the mast . As I inserted the all-thread into the tubing , I used Marine Grade sealer/silicone to secure any cavities as it was the ID and OD were not exact match . While spinning/screwing the all-thread into the tubing , I applied the silicone sealer onto the threads . At the tip of the tubing where it is formed as a natural flare is a plastic insert where the all-thread did make a good contact . The end of the all-thread is just short from passing all the way through , on which I placed a dab of silicone sealer to secure a chromed dog collar spike to complete the top of the mast . At the base of the tubing , I run a stainless steel safety nut (one with the plastic insert , forgot the correct name) reversed to give an acorn top look just under the tubing . The mount I made from aircraft aluminim . Measements are 3/4" x 2" x 1" . Drilled 1 hole to fit around the trunk rack and 2 more to secure it to the rack . 1 hole , I passed the mast into and tightend securely with an acorn nut . Second hole I used acorn nut up top and safety nut underneath . I would have used another acorn nut , but ran out of them . Also to mention , I used the over length all-thread as my second securing bolt . The flag , I purchased at Walmart just under $5.00 . It is the heavy duty , window type plastic mount , made of double layered fabric . I removed the flap from the plastic mast and inserted a section of pvc tubing into the tubular fabric on mount side of the flag . It was a tight fit , which made is better . I inserted the mast into the pvc tubing on the flag and followed it with up with a rubber grommet to keep the flap up top of mast . The rubbwer grommet is the type used to insulate wires through sheet metal which I purchased from hardware store as well . The way I made this will allow the flag to rotate freely around the mast . Overall , I have only spent nearly $20.00 for 1 flag and 2 flag pole mast and took me approx. 1 1/2 hours to make . Gene
