Search the Community
Showing results for tags 'adj'.
-
hello v7goose write up on carb floats only covers the measurment and not how to adj the float its self i had my carbs off but do not see how to adj the floats when i cruse at 60 the bikes acks like it needs gas but when i give it gas it will run fine as lone as i am acellerating i was told it maybe carbs flooding and floats need adj any help or what to do new fuel filter all lines clear kevin 1999 rsv
-
I've got an '83 that seems to run great when cold, but once it warms up it seems to drop a cyl.until you hit about 2500, then runs good, it seems to idle fine too. I've replaced the plugs and diaphragms. years ago I had a similar problem [i think] and it had a bad diaphragm. stumped now,think it might be valve adj? or electrical? If I just rev it up it sounds good, but on the road it doesn't matter how much I wash it, it looks like dung under 2500
-
I have a 08 venture. the cruise workes but when going down hill then an the way up it will lose about 5 mph then pick it back up to set speed. Would the cables be out of adj? I did adj the carb floats so it is possable I didn't get the cables just right! Thanks for input! Ps. the floats were way off from the book. Milage went fron 34 to 42. Don't put that in stone. I need to do some more checking on that part.
-
I have been reading different post on carb adj. sinking of carbs, float adj. ect. Now what I need to know is how to adj. the jets? How do you know if the adj. is right? with out some kind of air/fuel gauge it is imposable to know if all the jets are right threw all 3 ranges. Your idle could be right & mid range ritch & high end right. witch in turn would be lower fuel milage. Or at high speed the first 2 could be right & high range could be ritch. in turn lower fuel milage & maybe lower power? I know about pulling the plugs & checking them but that is not real acc. in all ranges eather.
-
Is there a horizontal left to right headlight adj. If so can it be adj without splitting the fairing?
-
how do i adjust,the spliter,what meter do i use,have turned the adj screws ,dose not seam to change anything:confused24: