Search the Community
Showing results for tags '1st gen'.
Found 5 results
-
I have a shop full of 1st gen Venture parts for sale. Body plastic, frames, seats, windshields, wiring harnesses, tires, wheels. If you need it I have it. Send me a picture of what you need and I'll let you know if I have it and a price. Did I mention I have it? The Fundi. -
Looking for Voyager trike mounting hardware, books or any install brochures for first or 2nd gen Venture Royale
-
A new clutch configuration appeared on the 1987 Ventures, and other Yamaha models at the time. I have a couple of questions - is it superior, AND will it fit into a 1984? I see a few for sale eBay. The 2nd gear issue finally caught up to me, so thinking about upgrading some things while the engine is out and apart. -
I posted a little while back about this, and I've made some progress. I was having tranny issues so I did an oil change and previous to that threw some SeaFoam in the case for about 20 miles, it seems to have cleared things up quite a bit, while as earlier I could only shift If I toggled the back wheel back-n-forth, and pressed crazy hard, now I shift with almost no effort if the bikes moving. My question then is three-fold. 1. Is it normal that when you go into gear from start that the bike jerks forward a little bit even with the clutch in? it's kind of sounds like a big "CLICK" puts the gear in place a jerks a bit as it does so. Is that normal? I've never had a bike that does that 2. Why is that I can almost never get into first when I'm not moving? 2nd's usually ok, but 1st refuses to go unless I rock forward a bit, is that normal? and 3. It probably sounds like a stupid question to you guys who are so familiar with Ventures, but where's the air filter on this bike? Thanks! James
-
So, I've heard alot about this infamous 2nd gear issue, I don't seem to have that on my bike, by struggle is getting into 3-5, the shifter won't budge past second, first,neutral 2nd all work, but it won't go further , i tried adjusting the shift , but after doing that I just ended up putting so much force into I bent the adjustment screw, any advice on what I should do or where to get a new screw?
