Jump to content
IGNORED

Need help with RSV wiring schematic


Recommended Posts

I am near completion on the RSV wiring schematic.

 

I have a number of questions about it that I am unable to check since I do not have A RSV.

 

What I need is someone that can look at a wiring harness on or off of bike and check these.

 

They are listed below.

 

If it would help I could email anyone interested in helping a copy of schematic.

 

I would like to get as many of these questions resolved prior to posting finished version.

 

There may be a prize for most needed answers

 

:think:

 

#1 Rear speakers only show 2 wires, if stereo rear speakers should be 4

Answered by YamaHamer 10/23/09

:bowdown:

 

#2 two of six wires from MCU to front radio remote go thru connector D, why just 2

 

#3 Is carb heart ground shown correct or do grounds all connect to Carb ground connector.

 

#4 Wire colors into fan noise filter conflict between what connectors indicate & indicated wire color.

 

#5 Rear Aux outlet positive wire color to fuse, Br/R or Br/B, wire has each on opposite ends

 

#6 Is Y/W wire color correct in rear brake switch, incoming cable shows Y/L

 

#7 Color of wire inside handle bar control from Cruise Control Switch to Hazard Switch, not marked on schematic

 

#8 Is Y/B wire correct color in clutch switch, incoming cable shows Y/W

Answered by BuddyRich 10/23/09

:bowdown:

 

#9 Is W wire correct color in PTT switch, incoming cable shows W/L

 

#10 PTT circuit problem….Harness connector legend does not show a W or a W/L wire going thru it, PTT circuit is indicated as going thru this connector though. MCU diagram indicates it is W/Y at connector but on other ends, indicates W/L at MCU and at push button it shows being a W, on cable going into push button it is W/L. Only one wire on schematic is W/Y, from MCU to Front Control & this does not indicate going thru D connector

 

#11 Is L/B wire correct color in dimmer switch, incoming cable shows R/Y

 

#12 Wire connector E, can’t locate Br/W terminal, only logical place is in wire from flasher relay to turn signal switch

 

#13 Wire connector D, can’t locate Y/R terminal, only Y/R at 2 places 1st out of cruise control relay, 2nd from flasher relay to turn signal switch.

 

 

.

Edited by dingy
Marked of answered questions
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...