dacheedah

Reasons not to circumvent the safety features, glad you are ok, thoughts of a rollover bar. . . we used to mow a steep hill and had counter weights and a bar that extended with wheels to help prevent rollover. I never liked mowing like that and I'm not sure who if anyone ever rolled the tractor did but it was scary stuff. When your instructions start with that side always faces uphill, don't ever get off on the hill, but if if you do get off you must go off on the uphill side. I knew someone before me had a bad day. heal quickly

if you havent already replace all the gas, put in a can of techtron and let it soak for 24 hours, drain and add fresh gas with a can of techtron and ride, after a tank change plugs.

DYN DNS I use them for my house camera

what did I come to this thread for

I thought that was how you got rid of the ex only using a clip on her and a door knob.

isolated is the way to go

steel toed tennis shoes

I'd drain all the gas including carbs and throw the old in in a car. Can of seafoam 100% and give a soak overnight. Drain the seafoam, add fresh gas and refresh the plugs. Too many additives in the gas can cause issues also. With the gas refreshed you can test the fuel pump also. See if it runs better

I would disconnect everything and charge to eliminate another electrical culprit. Check battery voltage when charged.

sooo R u renting a convertable or motorhome, we can say support vehicle

is that powered Joe?

supposedly if you scan your eyes left and right back and forth it connects both sides of your brain and is supposed to help you remember what the hell you are doing.

latest malware looks like adobe, and is nasty, usually when you try to play video's . Only upgrade any utilities from the actual supporting website.

We have bike races here once a year where they close down roads. . . and a guy with a goldwing pulls a trailer behind it with about 4 bikes, parts and gear. Point is you can have your cake . .

that was my question also, can i use the bikes audio system with the cb ...

Custom world international http://www.cruisercustomizing.com/custom-world-international-driver-backrest-yamaha-xvz1300-royal-star-venture-99-09/part/CWI-04-167

On the old kit they had about a dozen 12v bulbs with pigtails, rubber grommets and a drill bit with a stop. They were about 1/4" or smaller, you removed the reflector, drilled the back carefully, put the grommet in and slid the bulb in, wired into running lights and put back on. Never had an issue with them Sent from my iPhone using Tapatalk

http://www.artofmanliness.com/2014/02/19/how-to-make-a-drinking-glass-from-a-bottle/

And change the crush washer each time, torque to specs

pilot mixture screw (idle) in the carb I'm guessin

something like this http://www.instructables.com/id/Simple-LED-Bike-Lights/

I ride with snowmobile gloves when it turns very cold

I'm hoping that Yamaha comes out with a thong thing

my answer is yes, most definately

JC Whitney had a kit to do this to the rear reflector, I did it to my 89. Today I think LED's would be a better choice. If you can find some red led's, then look for a grommet to fit snug around the bulb. Drill the holes with a collar or bit stop, slip the gromet in and slide the bulb in. A dab of silicone may help secure them.