dacheedah

Message received, shouldn't u b out on da boat?

Glad you are ok

did you set the swr?

It will keep you from smoking your electrical system if the trailer, a light fixture or wiring developed a short

I would second on the beads, my experience is handling is better near the max psi

I am trying to see if the wife can do a trip, may be a bit longer, ill keep you updated. Kevin how long is the ride from us to you??

I have mic mutes, they are sweet

Walmart, go to fishin section, berkley sunglasses with readers built in the bottom. Different strengths and just $20.00

thoughts and prayers

used to use traps that was a square with triangles on each side. wired a chicken leg to the bottom and soak a short bit, quickly pull up and crab. we used several and filled a cooler in no time.

I agree refresh and bleed

If you are thinking of Tow Pac they are made a few miles from my house

Wife is grounded but I am up for one. Eusa wants us to do the longest bike thing.

Changed from 404 to E3, night n day difference. . . no Mar Bar works awesome

thoughts and prayers

stainless nylock nuts

How different is the motor? will the fuel injection adapt over??

http://www.venturerider.org/forum/showthread.php?t=68383I also replaced the tongue with 2" square tubing, went longer, welded up some angle for cooler rack, then added a bicycle rack. Pulls nicer with longer tongue, could have bought same tubing as they come with but I had the 2" on hand. Made a stand for the front that folds down. I ran with 4 flat wiring but Jeff helped out with a center brake light circuit so we can also pull with a car.

We always found a ditch to back the truck in and just ride on, no ramps. I notice that when the ramp is at a steep angle the bike bottoms out on the end of the ramp.

http://www.daily-journal.com/news/local/vintage-harleys-to-be-auctioned-in-manteno/article_304cb221-1d73-5af9-bf2f-43e793aa58b6.htmlThis was a nearby Harley Dealer that sold his business, now he is auctioning his collection http://www.daily-journal.com/news/local/vintage-harleys-to-be-auctioned-in-manteno/article_304cb221-1d73-5af9-bf2f-43e793aa58b6.html

Always learned to tighten to set the bearing into the race, then back off and finger tight plus 1/4 turn. Wheel should spin freely but when grabbing the outside of the tire and pulling side to side you should have no play.

cut the bottom and drill new mounting points

Or a video of the video of the drone going through

They didn't hear about your famous rum balls Jeff

Bike safety and parking lot drills with 1/2 tennis balls for cones. I suggest practicing left right evasive maneuver while thresh holding breaking, if they lock curl your toe's and right hand slightly to unlock the wheel while steering. Ride like a pro is very good rider training