Jump to content

edtheguy

Expired Membership
  • Posts

    55
  • Joined

  • Last visited

Reputation

12 Good

Personal Information

  • Name
    Ed

location

  • Location
    Lemont, United States

Converted

  • City
    Lemont

Converted

  • State/Province
    AL

Converted

  • Home Country
    United States

Converted

  • Bike Year and Model
    1988 XVZ 1300

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. After running a while and shutting off. Difficulty restarting
  2. Going to take another ride and check . What module and where is it located?
  3. Had my 88 apart a few times. Your post is excellent and I checked everything you mentioned. If still not working where do I look next? Thanks again.
  4. How can I get the correct paint color for my bike. Had to rebuild left side fairing did a repaint with colors I thought were close. But really dont like it. Anybody with info out there? Thanks . Its white and cream I think. 1988 white DU Creamy White/ Ceramic Ivory Taken from definitive color chart. Our post. I think these are the colors.
  5. Wow. Thanks for all the info guys. I have a lot of checking yo do.
  6. I know this is an old thread, but still having some issues. When it gets warm tends to idle erratically to the point where it may die. Temp gage only a little above normal. Is there a way to have the fan actuate at a lower temp ?
  7. Great advice fellas. Thanks a bunch . St.
  8. While removing rear wheel for tire change, removed rear caliper and noticed it has 4 pistons. 2 aren't moving causing pads to wear very unevenly. Thick on end where no motion and thin on end still working. Can I rebuild the caliper? How difficult is it? Who has parts? Would I be better off getting another caliper if possible?
  9. Great bunch in the club .
  10. Ok guys. You know your stuff. Re soldered all nine pins coming off plug and unbelievably the system is now working. Thanks so much for all your input. Great bunch in this cub.
  11. Had an E4 error . Bought used compressor assembly , replaced still getting an E4. Unplugged everything, still get ting an E4. What gives ? Does anybody have a layman's procedure of troubleshooting this system ?
  12. Hey guys, had an E4 error . Got a complete replacement unit from Michigan motorcycle sakvage. Installed it, still Getting an E4 error, any help would be appreciated.
  13. All the lights come on at speed (60). Does not engage.
  14. Where is the cruise control module thst is behind the headlight? What color are the wires? Is there a troubleshooting guide somewhere on this forum?
  15. Is it possible that I have some other problem? Lights still brighter than normal, volt meter pegged at 4000 rpm. Checked voltage at battery showing 13.5 to 14.5 volts even at 4000 rpm. Note this is with bike sitting. Seems like something else is going on when riding. Any thoughts?
×
×
  • Create New...