Thanks for the replies. 99% sure door seal is good and it is closed. (checked that).
There is little water in the drain pan at the back so freezing is a possibility.
The freezer is a slide out which is bigger pain to get into than the door I had left at the other house. It had a similar problem but was iced up behind the plastic panel on the coils. It needed some timer, but the repair man fixed that one.
Going away tomorrow (holiday) so the fridge is waiting a few weeks until get some time to look at it unless it breaks worse than it is now
Brad
Keeps everything cold and freezes water to ice cubes. Just over two years old. Not even sure the warranty that came with it.
Assume for 30 bucks each part it is still cheaper than a service man LOL
Thanks for the comments. Would you happen to know where these parts are located and or how to test them. (just re read and I will check you tube)
BRad
Thought I would ask here if someone can assist with an appliance. Have a 22 cuft Kitchenaid fridge, with freezer on the bottom. I have been getting ice build up on the inside at the bottom of the fridge. No water liners for ice maker pretty sure that is not the problem LOL.
I have recently cleaned out the dust from the front and rear twice with a shop vac. The last time I used the air gun and blew it out from all sides.
Seems like cleaning is not helping as much and the ice is starting to build up quicker.
Any ideas what to look for would be helpful before I call a service person in. Thanks
Brad
Would love to join you but the next week may not work. Late in the week maybe or on the long weekend if your around. Can you send an email with the phone would like to call if we are able to make it.
Don't forget Anna Maes on your way
Brad
Ground wire came off the inside casing of the light for me, had to solder it back on then was good to go.
Sarge did you try and shut the riding lights off to see if it helped ?
Brad
Too add to your theory.
My 99 had no issues at all with over 80k miles. The 08 I just replaced the fuel pump with 40,000 miles and the points looked exactly like the photo.
I hit reserve a lot more with the 99 than I did with the 08.
Brad
Hey Bob once it gets fixed don't let it sit so long.....Got more than 4k miles since mid May.
I would be looking at the ignition circuit. Not exactly sure where but that is where I would go next. Good luck Hope you get it going soon.
Brad
Stock 2nd gen will get hit with the ticket. If you have a light bar they can no longer see it.
Sauder's Trailers in St. Jacobs sells a nice little light ($ 40.00) I am trying to make a small bracket now.
Brad
I do as well but maybe not as hard as you because I think I do fine on the Venture. Never had a wing but I think I know what your saying. Maybe you should have had a first gen..
Anyway it would be nice to meet you at one of the meets, all the best
Brad
Check the following link to make sure it is admissable. If not you will not be allowed to bring it into the country, or will make you remove shortly after you get here.
List of instructions, on how to import.
https://www.riv.ca/
Brad
Glad you made it okay, sounds like you did good. Maybe a little oversight coming in though. Think we have all had that pucker feeling and it sure wakes you up.
As for pulling a trailor well a lot of us did that as well. A trailor is a funny thing and it acts different everytime you ride. I found that more tongue weight is better and that any heavy weight behind the axle causes a swing no matter how much tongue weight there is.
Enjoy and glad you made it
Brad
82 would have thought he was older than that as I too listened to him for what seems like forever.
Travelled a lot by car so you were most likely going to listen to him. All the best to the family.
Brad
If you have a bad battery I would find stop to look for a new one real quick. Stator or rectifier now that one is a slightly different story and it depends where you are.
My wifes Victory has the same battery and it has been swapped once before.
Brad