Yammer Dan

Yeah Pics of that garage right now would be cornfusing!!! 1st Gens, 2nd Gen, 4 wheeler, Ton of 1st Gen parts. Tools,Tools, and Tools!! I'm gonna have to cut down on the stock...somehow!!

Pics??? Wait til I get them Married and cleaned up a bit!! Pics of "Ugly" are here somewhere! When I took her Bear hunting.....

I had a 67 Triumph. Pretty good old bike but the wiring was crap!!

What ya mean Not Pretty??? Its BLUE Ain't it?? As Pretty as they get!!!

I'll give the Skidster that. His bike gets rode almost as much as mine used too. I said used too...... Ashville next week and I ain't got one going. Just ain't what I used to be!!

The Warden wasn't keeping me busy enough I guess!!! Got a awful familiar looking 1st Gen in the garage!! Good looking 85 with floorboards and a few extras. And a Voyager kit. Guess I'm gonna have to get busy!!! Looks like that 1st Gen was about to run over that Jeep! THANKS Skid.

Heat continues. Prayers Up!!!

When did it get dirty??

I think I rode that thing once!!!

I watered my Hot peppers. They are too hot to eat. Thought the water might cool them down???

Cute little Stinker!!

Tent poles are useless if ya got handlebars to hang the tent on.....

Nice morning. Prayers Up!!!

It is mostly the hookups to the rear axel I'm concerned about. One forward one backwards?? Pre load is interesting. Belly Pan explains itself I think. Do you remove Center Stand?? Lot of questions.

Dang!! Ya getting Old!! Have a great one!!! Quickly.......

NO!!!

I used to weld with 6011 rods at 300 amps. Ya gotta be quick.......

How much air pressure does it take?? Different for different guns?? About what pressure would you start with??

I need a Manual or a You Tube Vid or something that shows how to put a Voyager Kit on a Venture. You know just in case I were ever to get one. I think I can figure out most of it but the How To's would be nice to know before You take off down the road at about 110 mph.... I can't find info on the hook-up on these things. Anybody know where I can find them??? Would like to have paper manual but whatever it takes to get install info. 1st and 2nd Gen same?? You must remove Center Stand from 1st Gen? How it hooks on axle. what you measure where. how tight?....little things like that!! Can't find install info. Several sites claim to have but when you look they don't cover enough to make a safe experience of this.

I can lay it on pretty good Bob. Painted a few jeeps and APC's for Uncle Sam. Just don't remember anything about setting the gun up. But my trigger finger works Great!!

Garage a lot cooler at night. Prayers Up!!!

If plugs are fouled it will be very hard to start.

I was a Last Responder!!! :Avatars_Gee_George:When everybody else got done with them I got to tuck them in every night!! Wouldn't me coming around to say GOODNIGHT!! just be the high point of your day in that 8x12??

Ace Hardware. Big Chimney W.V. Downstairs. Got a bunch of chrome goodies.

Walked outside. Figured it was too hot for anybody with good sense to be out there. Stayed a minute or two and figured it was too HOT for ME also!!!