usnavyvet72

Where is the location of the meetup in sturgis... I am staying in rapid city... I rode my 2000 RSV MM Limited...thx

Is there a meetup today for venture riders?, i am in rapid city and can make it... Location?? Thanks...

How much did u get it for?? I like those as well

lol....but i got a hit....thx..

the dealer setup via star truck , last year they were in a park correct?

as a Veteran ....I enjoy always stopping there at the Black Hill National Cem......I have some great photos I shot of there....its a great stop....

I will be there on my MM Limited as well... Sunday Eve....Caming over in my usual KOA Rapid Cty..

2000 Royal Star Venture MM Limited.....opps....

WOW.....I am hoping to depart Illinois Saturday and arrive late Sunday....Been going since 2007...AND I ALSO OWN a 2000 Royal Star MM Limited....I forget the #, but the # tag is under my trunk twilight on Lid....are u riding or trailering.....I'll be riding , as my Lady is going on a trip later this month on a MLB tour with her parents....I too hope to be in Sturgis oil the 14 as well.....I camp in Rapid City.....KOA...been a great stay since 2007, great staff and CLEAN....

correct....this is the normal stop for them...I usually see a few chapters with a storefront in Sturgis every year...I have some "81 supporter " stuff...hope to get another shirt or so this year .....I leave Saturday....providing my rear caliper co-operates ...lol just had a froze piston and caliper redone....

ahhh sorry....thx

i have a 2000 Royal Star Venture, and it was in the shop to get the rear air shock replaced 'which i found a great low mileage one for 150.00, and a new rear rotor put on..first issue i notice when riding home was it felt there was a drag...so i pulled over and rear rotor was SUPER HOT to the touch....pistons looked extended and not floating back , so i let it cool down and proceeded a short distance home and returned bike back to the shop...he suggested there was crud in master cylinder...so i got lucky and dealer has a rebuild kit in stock, so i ran and got it and the shop my bike was in rebuilt and pneumatical bled the rear system....he said the was gunk in the Cylinder and seems ok....i rode it home and for a little bit it seemed ok...so i took it for a ride and whammy caliper was sticking / causing heat and drag again....so should i be safe to bet, after i looked under dust cover and discovered the slide pins and contact pints for pads were dry / no lube!! and the pistons look a bit dirty....shall i emery cloth the pistons when i extend them and give caliper bad area a good brake cleaning , lightly sand pad contact areas as well and apply a little lube to contact pints and slide pins???? is that safe to say??? i leave for surges on saturday....and rather not have this issue on the road.....btw....the dealer doesn't stock the caliper service kit.....so this i feel is the choice to do to see if that does the trick.......and help on this would be appreciate ...thanks in advance....