Jump to content

flb_78

Expired Membership
  • Posts

    2,702
  • Joined

  • Last visited

Everything posted by flb_78

  1. Unless your going to get all 3 pieces, they will be terribly mismatched. You could also look into the aftermarket arm rests from Diamond R. Still 200 bux, but at least they would match. http://www.diamondraccessories.com/Merchant2/graphics/00000001/tubulararmrest.jpg
  2. Ive been using the PL14610 for over a year now and a half a dozen or so oil changes, I also used it on my Roadstar. Works fine for me.
  3. Some people will not recommend it, but I personally have almost always have had mismatched tires will no ill effects.
  4. I met up with Lowell today for a little bit as he was passing through Amarillo. He is doing good. He is now running a car tire on the back of his bike and he is loving it. I should of taken a camera and taken a pic of our 2 bikes side by side with matching car tires on them.
  5. I saw Lowell today and his bike wasn't in a ball of flames!!! It's amazing!!! So far, he LOVES his car tire. Smoother ride, more control, better rear braking...
  6. Im assuming that you mean the passing lamp light bar on the front of the motorcycle. You will need to tap into the headlight harness to add a relay.
  7. Since he doesn't own a 2nd gen, I would assume he would want the trunk for his Nomad.
  8. The chat is Flash based, if you have a flash blocking program, you can't use chat. I have to change my settings to use the chat room with my flash program blocker.
  9. If you just paid them a butt-load of money to fix your bike and it comes back worse then when it went in, I do believe they have some double checking to do. I wouldn't touch anything until they went over the bike again. If you start tinkering with it and make it worse, they'll claim that you caused the problem to begin with.
  10. Hey!! I'll be in Amarillo all day Sunday!!
  11. I didn't use a gasket on my cover. I used Loctite 515 gasket eliminator. I didn't use a torque wrench either, I have calibrated wrists!!!
  12. Filters are interchangable, you'll be fine.
  13. I lock up my rear wheel on purpose!!!! It's fun!!
  14. NONE SHALL ACCESS!!! http://www.toymania.com/columns/spotlight/images/ssmpblackknight3.jpg
  15. Hey, the site was down earlier.
  16. Take it to the dealer, it's warranty then. The only thing that I can think of is that the switch in the center of the fairing as come unplugged.
  17. If ya'll were to put speedohealers on your bikes, you'd get another 7mph out of the cruise because your factory speedometer is around 8 percent off. 85mph @ 8% is 6.8 mph that your are loosing.
  18. I ask that this thread not be allowed as a Meet and Eat. A Meet and Eat is properly announced and posted so that others may know about it and make plans to attend.:rotf::rotf::rotf:
  19. Come to think of it, Ive never even heard my fan come on!!
  20. Silly question, but I have to ask. Did you check the coolant level in the radiator itself and not just in the plastic tank? I have to agree that if it was running that lean, that the bike would not run properly.
  21. Yep, you're not going to hurt the engine by bouncing it off the rev limiter. It's too low from the factory.
  22. Whoops. I was way off on the torque of the Venture. Yes, it's 98hp and 89lb/ft of torque. I will edit my first post to show this.
  23. You're wasting your money and carboning up the top of your pistons using premium. 73's N9OHM
  24. That's odd... Youtube is down. The entire thing is down.
  25. Seems feasible to me. It appears and operates like a modified Segway.
×
×
  • Create New...