Money Venture

When you checked the battery after the smoke, did you physically take the battery out and clean the posts or just check it with a meter?

Come on Puc, everybody knows the Blue ones are the fastest.

GREEN LIGHT FLASHING – When the green light is flashing, the battery is greater than 80% charged. For BT Plus models the red light will also be on steady. (Note: Does not apply to the 8V Plus or the 6V Junior).

I use electrolysis. It isn't as fast as mechanical or chemical removal but it doesn't need to be neutralized and it doesn't eat anything but rust. Of course you will probably need a 55 gallon drum or so to fit the frame in it. If you want the details, I can send along what I do.

http://www.venturerider.org/forum/showthread.php?489-Battery-Warning-Bypass

Rent an ozone generator. Run it over the weekend with the doors and windows closed. It actually kills the smell it doesn't mask it.

OK, I'm getting ready to do this on an 87. On the above stage list is Doc's kit the heavier springs or the Barnett springs? On my Honda 550 years ago I went with a Barnett Clutch and 305 springs. It strengthened my left forearm but I was younger too. All I want is something I can ride two up maybe a small trailer down the road and no slip when accelerating in higher gears. I like to play sport bike sometimes but in a pretty tame way. Oh Yeah, what is a PCW?

Yes, the bottom one is what I had. So they were just worn out. It rides so nice now. And sits at the right height too!

So, last weekend, I replaced the springs in the front of my 87. The old ones were 4-5 inches shorter than the new ones. There were 4-5 inch plugs that were inside the tube above the spring. The old springs were wound like a progressive spring so I am guessing they are a different brand like a Sonic? Anyway, I didn't use the spacer I just inverted the washer with the lip in it and used the factory cup under the threaded plugs. It sits right and rides nice. I am just curious if the PO replaced the old springs with the wrong ones or were they also worn out because with out air it was bottoming out in the driveway.

Thanks Kevin!

I have seen multiple part numbers for the brake pads for our bikes. Do the FA123HH fit the 1987 Ventures? All three positions? Around $30 per rotor? Thanks.

My wife and I traveled with my daughter and her husband this past fall on the bikes. We have the Sena 20 headsets. All four of us talked back and forth. I also had music playing and GPS turn by turn all at the same time. I was against getting them due to the cost. I now can say if I had to, I'd buy them all over again.

My GPS is on my phone in my pocket talking to me through bluetooth headset. No wires.

Molasses from the Farm store cleans up rust on metal that you can't get too. Takes a few days but it cleans good. I have used aluminum foil to clean chrome. Works good too.

What brings one to Yellowknife for 18 years?

We just sold our Class A this past fall. Had it 19 years. Loved every minute of it. Family grew up and we didn't use it anymore. I'm on my third boat. Bought this one in 2004. We'll keep it a while longer as we are still having fun with it. Good Luck on your purchase.

Did you check the polarity of your LEDs to make sure they are correct?

The fracking isn't the problem. The problem is the companies take short cuts and don't install the liners or don't line correctly or deep enough. Then you get contaminated aquifers.

I couldn't decide between them so I put both up. Hope you don't mind.

http://crimeblog.dallasnews.com/2013/04/wrongfully-arrested-motorcyclist-who-had-helmet-cam-seized-by-dallas-county-sheriffs-deputy-sues-for-1-million.html/

http://www.xs11.com/xs11-info/tech-tips/maintenance/brakes/23-the-great-dot-brake-fluid-controversy.html

Come on, we all know Blue is the fastest!!!

I don't know the Venture CB, but CBs in general used the PL-259 connectors.

Take care and get well Jeff.

Also, if you don't post pictures, it never really happened!