cachris

Thanks everybody for the information. Yes the neutral light is working so I guess I will start from there and working my way down

My at 83 will not start when in neutral. But when you put it in gear it starts as long as the clutch handle is pulled in. Any thoughts? Thanks Chris

thanks that was it. the right side is now flashing. not the prettiest job but got it done. http://img.tapatalk.com/d/14/04/17/7e3u9y7a.jpg Sent from my SCH-R910 using Tapatalk 2

think I found the problem I have a green wire that's not soldered to the switchhttp://img.tapatalk.com/d/14/04/17/9e8e3usu.jpg Sent from my SCH-R910 using Tapatalk 2

thinking the switch may be sticking and not a lot on the right side turn on. Sent from my SCH-R910 using Tapatalk 2

thanks everybody I found the 4 Way switch all flashers work when the 4 Way switch is on. the left turn indicators work correctly. however neither the front or the back right indicator will flash. Sent from my SCH-R910 using Tapatalk 2

Flashers not working Anybody got an idea why my indicator lights in the front would light up, but not in the rear. Both the front and the back are not flashing. Checked the wires in the rear and I'm not getting power to either side in the rear. I'm getting power to both wires going to the flasher. Thanks Chris

Sure Sent from my SCH-R910 using Tapatalk 2

should I go ahead and replace this relay? Sent from my SCH-R910 using Tapatalk 2

Neil my phone is not allowing me to make the phone call. are you outside the United States? on a good note I tried banging in the really against the frame and it is now working the bike crank over and started up. any idea why that might have worked? thanks for all your help ! Sent from my SCH-R910 using Tapatalk 2

I'm now getting 11.5 volt on one red wire and the other red wire I'm getting 2.9 volts Sent from my SCH-R910 using Tapatalk 2

tried that. where's the starting circuit relay Sent from my SCH-R910 using Tapatalk 2

can I swap relays out just to test http://img.tapatalk.com/d/14/04/14/vugaba3u.jpg Sent from my SCH-R910 using Tapatalk 2

just tested the relay again and now I'm getting power to one red wire Sent from my SCH-R910 using Tapatalk 2

http://img.tapatalk.com/d/14/04/14/adazune8.jpg Sent from my SCH-R910 using Tapatalk 2