nu2this

Ok so I messed up and now have two post going it is not the driveshaft all movement and splines are good however when I pull the clutch in it seemed to not have the proper effects pulling the clutch. In while in 1st did not disengage the gear could this me a slave cylinder issue?

Driveshaft was good how likely is it that clutch is stuck half engaged heich is causing some weak movement but not allowing full gear engagement where is a good place to buy a manual

Ok so hello everyone got a few tech questions first let me explain the situation I picked up a 1983 venture a week ago I took it on a couple mile test ride no issues I took it to the store (a few more miles) no issues then I took it on the 30 mile trip to work the whole way up the bike ran great no issues I got to the stop light before work and shifted into neutral when the light turned green I shifted into first and all I got was a slight grinding noise more of a grumble than a grind she shift easily into all gears but the is no drive or pull when the clutch is released ? I have since pulled the rear wheel and when I pulled it I started the bike and shifted into gear there was movement but it was weak enuf to not spin the tire so I pulled the rear drive and shaft it seems to be fine all splines are good and no unnecessary play I pulled the left cover off and when I pull in the clutch and shift from n to first the nut in there doesnt spin freely but in n it does any ideas as to what the hecks going on? If I did a poor job of explaining please feel free to ask any question or make any correction

Ok so hi all I have a problem and was wondering if anyone can help bike is a 1983 venture royale 1200 55k just got it test rode no issue drove to the store no issues then I took it on the 30 mile trip to work the bike rode fine until I got to a stop light shifted into neutral no noises or grinding squealing or hard shifting the light turned green I shifted into 1st and nothing except a grinding noise this is through all gears no power to the wheel it sounds like the noise is at the final drive but im not sure I havent taken the bike apart yet does anyone have any ideas no visible fluid leaks