Leaderboard

Today I spent a little time on the Venture tinking with some plastic repair issues. The ride side panel that holds the CB and air controls was a little busted up at the mounting holes. So I tried some simple rubber tapered washers to help hold the panel in place. You can watch the short video here:

Just an update, got everything put back together. Did very minor adjustments on the float height but had two of those rubber plugs on the jet blocks almost totally pushed out. Thanks to cimmer for mentioning that, need to synch the carbs and take it for a run to see if I find any improvement!

You could always just become a full member, that way you could share with others as well.

Here is a set up I threw together in a pinch to wet set my carbs on the bench any variation of this would work. The key factors are a pressurized fuel source at a steady 3.5 psi (an air tight container with a tube going to the bottom which supply's gas to the carb and a metal tubeless tire valve secured to the top to add pressure ) the clear plastic tubes installed on the drain holes. I have since Used a different set up much more compact and simplified but I have no pics. however the attachment should give you the jest of it. Home made set up for wet setting floats on the bench.pdf