Check all motor vehicle regulations before beginning
THE OWNER OR INSTALLER ASSUMES ALL RISK AND LIABILITY
DO THE MATH OF A LEVER SYSTEM BEFORE YOU START THIS DOES WORK
This operation should be performed by a certified shop
Before beginning set the rear shock to the lowest setting
You can drop the bike ( 1 3/8 inches )by bringing the pin of the shock lever mount under the rear swing arm 1/2 inch lower .
This bring up the rear wheel about 1 3/8 inch up , and will lower the bike
Install a 120/70 R 18 tire in the front , rear tire 150 / 70 R16 ,,tire pressure should be maintained at 40 psi
This will give you 5 1/2 inches of room above the rear wheel
Front fork pressure 20 psi plus is required to make the lever work ( this equalize the level of the bike )
Depending on operator weight set rear shock pressure 20 psi ( higher psi will raise the bike )
You will have to shorten the side stand 1 inch , if you so not shorten the side stand the bike may fall to the right.
Take one inch of the top of the seat
This change will let anyone being 5ft 6 inches tall put the feet flat on the ground
Overall the bike will be 1 1/2 to 2 1/2 inches lower