~Yamaha Billet Air Filter covers with K&N filters
~Yamaha Billet Carb covers
~Yamaha Billet Choke knob cover
~Yamaha Billet Engine Breather covers
~Yamaha Billet Motor mount bolt covers
~Yamaha Billet Oil Filler cap
~Yamaha Billet Passenger floorboard backing
~Yamaha Billet Passenger floorboards
~Yamaha Billet Master Cylinder covers (clutch and front brake)
~Yamaha Billet Front Brake caliper covers
~Yamaha Trunk Rack
~Baron 1" handle bar risers - Added rubber blocks to extend existing rubber block that stablizes fairing.
~Yamaha Leather Gas Cap cover (keeps reflection off windshield)
~Yamaha Saddle Bag Liners
~Yamaha Trunk rack bag
~Yamaha Passing lamps
~Yamaha Tinted lower wind vents
~Yamaha Travel Trunk wing with LED light
~LED tail light (100 LED Super Bright)
~6" LED lights side under travel trunk - RED - low intensity with running lights and blink with turn signals.
~Knight Rider chrome license plate frame. Sequence back and forth with running lights and blink 3-5 seconds when brakes applied.
~3" LED red lights custom mounted under back of saddle bags. Work as running and brake lights. Strobe with strobe unit.
~LED turn signals with metric load equilizer
~LED replacement side reflectors ( installed relay to allow them to blink with turn signals)
~LED brake light strobe unit. Strobe LED tail light, trunk wing LED lights and 3" LED lights under saddle bags. Programmed to strobe 3 times then hold solid. see this link http://www.venturerider.org/forum/showthread.php?t=32917
~Tented lower wind deflectors and clear plastic on front fairing black.
~Kuryakyn chrome volt meter with key switch actived relay
~Install relay to remove load from key switch.
~Install aux fuse block (6 circuit) under seat.
~Butler thumb screws to attach rear saddle bags
~Front mud flap (modified JC Whitney)
~XM roady ll mounted on handlebars ( power supplied from under front fairing and audio jack split for Aux selection) Also set up to use Ipod here.
~Butler seat mod front and rear
~Utopia drivers back rest
~Kurakyn long horn dually highway pegs
~Removed stock 404 tires with only 5400 miles. New Dunlop Elite 3 on front and rear
~ Zumo 660 installed and works great.
~Install FM Direct adapter under fairing for my XM Roady ll, so I can use the split Aux audio for my Ipod and not have to swap from XM to Ipod.
~Install Revco Dual Air horns.
~SpeedoHealer installed.
~Removed chrome wiskers from fron fairing.
~Moved XM radio to a RAM Mount on the right side and also added a RAM mount cup holder.
~Installed Black Carpet Saddle Bag and Trunk Bag liners
~Yamaha Billet single shifter installed
~Yamaha Clutch Basket upgrade from an "F" to an "I" Basket...big difference
~PCM clutch upgrade.
~Krome Works aftermarket Exhaust installed.
2 PAGES OF PHOTOS...go to page 2.
- Album created by CMIKE
- Updated
- 36 images
- 148 views
0 Album Comments
There are no comments to display.