bmannon Posted September 5, 2008 #1 Posted September 5, 2008 are these mufflers direct bolt on replacements for a first gen? http://www.macperformance.com/store/category.cfm?SID=3&Category_ID=912&Catlevel=3 wondering because it says they fit ''all models''
Condor Posted September 5, 2008 #2 Posted September 5, 2008 are these mufflers direct bolt on replacements for a first gen? http://www.macperformance.com/store/category.cfm?SID=3&Category_ID=912&Catlevel=3 wondering because it says they fit ''all models'' Pretty much a direct bolt on. You'll need to swap out the bolts to shorter ones, and mess around a bit getting them on, but they're made to replace the OEMs.
bmannon Posted September 5, 2008 Author #3 Posted September 5, 2008 Pretty much a direct bolt on. You'll need to swap out the bolts to shorter ones, and mess around a bit getting them on, but they're made to replace the OEMs. OK Thanks, I was looking at the originals that are on the bike and it looks like the have a bend in them, and I wasnt sure if that was built into the muffler or if it is a seperate piece.
Condor Posted September 5, 2008 #4 Posted September 5, 2008 OK Thanks, I was looking at the originals that are on the bike and it looks like the have a bend in them, and I wasnt sure if that was built into the muffler or if it is a seperate piece. All one piece....
bmannon Posted September 5, 2008 Author #5 Posted September 5, 2008 All one piece.... So just to clarify, the Macs have the bend in them also?
Condor Posted September 5, 2008 #6 Posted September 5, 2008 So just to clarify, the Macs have the bend in them also? Yes...... if they didn't have a bend they wouldn't be slip-ons........
bmannon Posted September 5, 2008 Author #7 Posted September 5, 2008 Yes...... if they didn't have a bend they wouldn't be slip-ons........ Thanks a lot for the responce, I just wanted to make sure before I ordered a set because if I had to fab up a bend I was just going to get some of the super cheap turn downs that JC Whitney sells.
Condor Posted September 5, 2008 #8 Posted September 5, 2008 Thanks a lot for the responce, I just wanted to make sure before I ordered a set because if I had to fab up a bend I was just going to get some of the super cheap turn downs that JC Whitney sells. No Problem. Check the link out. http://www.venturerider.org/forum/showthread.php?t=22324
bmannon Posted September 5, 2008 Author #9 Posted September 5, 2008 No Problem. Check the link out. http://www.venturerider.org/forum/showthread.php?t=22324 sent you an e-mail about those extra sets you have....
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now