Kuryakyn grip removal

[BigD]

Hey Guys & Gals, I need to remove and reinstall my left Kuryakyn grip. What is the best way to do this? I have got it to twist some, but it looks like it is pulling the rubber away from the grip. Thanks for any help.

[Tartan Terror]

Hey Guys & Gals, I need to remove and reinstall my left Kuryakyn grip. What is the best way to do this? I have got it to twist some, but it looks like it is pulling the rubber away from the grip. Thanks for any help.

Actually it will. the rubber is an insert that goes inside the chrome part. if they seperate you can put the rubber back in after you get it off. I usually slide a long thin flatblade under the grip to seperate it. You may need to remove the switch housing and master from bar to get the right angle.

 

Scotty

[Squeeze]

Hi,

 

remove the left Side Switch Assembly and bring in your Compressor and a Airgun. Lift the rubber with a small Screwdriver and blow the Air in the Gap, move the Screwdriver around the Handlebar and follow it with the Airgun. Once your done the complete Turn, you should be able to turn the Grip and pull it from the Handlebar while turning and blwoing Air between Rubber an Handlebar.

 

On the right Handlebar, it's better to take the Switch apart and remove the complete Grip. If you turn the Grip with too much Force, a Cable could be going weak or you tear it apart. Once you have it in Hand, you can use the same Procedure as on the left Side.

[BigD]

Thanks Guys, I will try this this weekend.