Jump to content

Recommended Posts

Posted

The door on the cassette deck popped open and now won't stay closed. Short of using duct tape to keep it closed, can anyone tell me how it latches and what I can check?

Posted

Spray a little lubricant in the upper (right?) corner. Latch has probably dried out. Mine did it about two years ago about the same time helmut latches dried up.

Posted

Mine did that and it ended up being broken. Dealer replaced the whole unit, cause you can't just replace the door, under warranty. Until the part came in I wedged a nickel in between the side of the door and the frame. It worked pretty well. Never came open. I would have probably left it that way if the dealer wouldn't have been willing to replace it.

  • 1 year later...
Posted

Funny thing. My door wont open. Its stuck closed. I dont have casettes and dont have MP-3 player yet, so closed it will stay until I get an MP-3. However the thread is good to know about. Write on Bruddha's.

Posted
The door on the cassette deck popped open and now won't stay closed. Short of using duct tape to keep it closed, can anyone tell me how it latches and what I can check?

 

 

Don't use duct tape when it dries out you won't be able to get the glue off. Worse yet is dried on masking tape. On cars it cam off with steel wool and lacquer thinner. Just a heads up.

 

Steve

Posted

I don't use the cassette any more. The door kept falling open and then the cassettes started jamming and I would need a knife to pry them out. Door is now permanently shut.

Posted
Funny thing. My door wont open. Its stuck closed. I dont have casettes and dont have MP-3 player yet, so closed it will stay until I get an MP-3. However the thread is good to know about. Write on Bruddha's.

 

Mine wouldn't open, at first, and I just kept pushing it all over until it finally came open. Then I noticed that the screws that held the faceplate onto the frame were loose. Tightened them up and everything was good after that. Might push the face plate up and down to see if that facilitates the door coming open.

 

Don't know if the screws are the problem on the ones that won't shut but it's worth a look see.

Posted

I had another cassette lid problem. As I recall, my 88VR spring loaded hinge mechanism (that pops out the cassettes) is attached to the CD cover by way of friction fit over four small plastic lugs on the cover. Two or three of these plastic lugs broke off the cover and as a result, I could not open or close the cover properly. I tried gluing the lugs back in place, with some success.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...