Spark plug caps/coils

[Venturous Randy]

I have a set of six coils off a Nissan Maxima engine that have the coils right on top of the sparkplug boot. I was wondering that if they would fit on top of the plugs on my bike, could I bypass the coils I have and run the respective wire that goes to the coil to the spark plug coil. I believe they only require a hot wire and a ground wire.

Has anyone done this? I don't see why it would not work if the room in the plug area is suffient.

Any comments?

RandyA

[Denden]

If the coil primary resistance isn't correct, you run the risk of frying your TCI. Primary side resistance should be 2.7 ohms +/- 10%. Secondary side resistance for stock is 13.2 k ohm +/- 20%. But I'm not real sure the secondary resistance would have any affect on the TCI. But make sure the primary side is in the range.

[Venturous Randy]

Thanks Dennis, It would probably be a fluke if the primary side was near the correct range, but I will check it out. These things may not even fit into the required area. I will let you know what I come up with.

Thanks,

RandyA