Making your own gaskets

[Geobob]

I am planning to make my own gasket for my middle gear cover and looked at ways of making a pattern.  It occurred  to me that if someone had a gasket set and scanned them we could have patterns available on line ready to print off.  If you could feed gasket paper into your printer that would be even better.  At a minimum having a pattern would make cutting your new one that much easier.  

And lets face it these gaskets are not going to be available forever.  Better to have a digital copy of all of them for future use.

Edited November 20, 2020 by Geobob
misspelling

[SpencerPJ]

I usually take a piece of paper and press around the area to make an indent, and go from there.