Confused on ordering friction plates

[Chaharly]

Going to be doing the Barnett Clutch upgrade and went off of the information on the read only section. Heres a link to that http://www.venturerider.org/forum/showthread.php?491-Barnett-Clutch-Installation

 

My I cant find the un-notched friction plate. Also they retaining wire can be thrown away am I right??

[cimmer]

Check out this write up. It is for a 2nd Gen but the clutch is the same as the 1 Gen MKII, which is what we have. I used it and it helped a lot with then I did this.

http://www.venturerider.org/forum/showthread.php?10518-Clutch-Upgrade

I didnt do the Barnett upgrade but used an EBC Diaphragm clutch spring instead as it was simpler to set up. I have found it works great for me.

 

Rick F.

[Chaharly]

Check out this write up. It is for a 2nd Gen but the clutch is the same as the 1 Gen MKII, which is what we have. I used it and it helped a lot with then I did this.

http://www.venturerider.org/forum/showthread.php?10518-Clutch-Upgrade

I didnt do the Barnett upgrade but used an EBC Diaphragm clutch spring instead as it was simpler to set up. I have found it works great for me.

 

Rick F.

 

Thank Ya Cimmer! I'm going to order the kit from Skydoc with the friction discs. I figure its 30 years old, I might as well