OrlinEngh Posted December 10, 2016 Share #1 Posted December 10, 2016 I will be getting the 86 I bought this fall a lot of cleaning and buffing and it should be ready to take to some shows this coming summer, mostly just for something different to do and have some fun. The 84 new tires and a set of coils and just some tinkering. The 2000 it will get tore down and a good going over to have it ready for next summer, No big upgrades unless I run across a good deal on some Vmax parts. And I have a few bikes coming in for some detail work so I have plenty to do on those days Im not out plowing snow. Orlin Link to comment Share on other sites More sharing options...
snyper316 Posted December 10, 2016 Share #2 Posted December 10, 2016 What I have done so far to my 83 is pulled the carbs out, Checked floats and adjusted slightly. Number 2 was not closing all the way. Replaced all screws with Allen heads. Watching an Item on ebay getting ready to bid on it. Then I will be putting that item on my bike. Sealing up the YICS box and possibly putting it back in. Just kind of working as time and money allows. One question would be I put 4 shots of seafoam in the tank and it is full. The question should I put the carbs back on just to start it or will my non ethanol gas be OK? Also Tues will be going to the plumbing shop in Joplin to see if they have the Abs Plastic and glue to do a few plastic tabs and repair. Then February I am gonna take a leap and order that TCI I found and try it out to see if it performs well. Will give my reviews on it, Take it out to have the guy at the shop spin it up to see what he thinks of it. He knows how these Ventures are supposed to run. Also will be getting the Morgan goodies to set mixture and balance. AS far as the 07 Rebel I will be pulling the tank and carb to clean both. Then put evapo rust in it along with Nuts and bolts. Replacing the Petcock on it as the reserve side just drips also when it is on position I don't think it has enuff flow when you get up in the 60-70 range it cuts out sometimes. After blowing air back thru it cleared it up for a little while. Also any suggestion for the 83 Accessory lamps for the front crash bar to both be seen better and see better at night. Was looking at some LED lights but they all say FOR OFFROAD USE ONLY. Will also be putting Leds in where I can so less draw from system. Will also be getting me an AGM battery and new windscreen for it. Mine is so scratched up it darned near blinds you at night when light hits it. Link to comment Share on other sites More sharing options...
bongobobny Posted December 10, 2016 Share #3 Posted December 10, 2016 ***Sigh*** Unfortunately, nothing because it is stored away in the neighbor's garage for the winter with no room to work on it. I might try to acquire a few goodies for it to install next spring... Link to comment Share on other sites More sharing options...
vzuden Posted December 10, 2016 Share #4 Posted December 10, 2016 Going to pull the swing arm to clean and repack the bearings. Get that back together and then pull the steering head bearings to clean and repack them. Link to comment Share on other sites More sharing options...
gmarshall Posted December 11, 2016 Share #5 Posted December 11, 2016 Going to ride on nice days. Like yesterday is was 55 after hitting 0 overnite Thursday. if you don't like the weather in Colorado, just wait an hour or two. Link to comment Share on other sites More sharing options...
Eck Posted December 11, 2016 Share #6 Posted December 11, 2016 I plan on riding all winter long................... Link to comment Share on other sites More sharing options...
bongobobny Posted December 11, 2016 Share #7 Posted December 11, 2016 Hey, Eck, do the words "me" and Bite" used together in a sentence mean anything to you??? Link to comment Share on other sites More sharing options...
snyper316 Posted December 11, 2016 Share #8 Posted December 11, 2016 Hey, Eck, do the words "me" and Bite" used together in a sentence mean anything to you??? Heck I could ride all winter long too, Except the cold one's but I want to get stuff done to it. Link to comment Share on other sites More sharing options...
tufftom4 Posted December 11, 2016 Share #9 Posted December 11, 2016 (edited) I will be riding, Christmas I am taking the motor home to St Augustine and towing the bike and camping, I am going to leave the trailer with the bike hooked after I come back and then head to Dunellon Fl. The IBMC is having a camp out to bring in the New year and I am going to meet them there, we rented the whole camp ground out. Edited December 11, 2016 by tufftom4 Link to comment Share on other sites More sharing options...
slowrollwv Posted December 12, 2016 Share #10 Posted December 12, 2016 Nothing my garage is too full of stuff to move around in to do anything. Link to comment Share on other sites More sharing options...
yamagrl Posted December 12, 2016 Share #11 Posted December 12, 2016 I think I'll go to beach tomorrow. Can't get my cast wet though. Link to comment Share on other sites More sharing options...
bj66 Posted December 12, 2016 Share #12 Posted December 12, 2016 My plans are to look at it sitting in my garage as I get in my truck on my way out to the ice shack. After the hectic fall that I had, piece and quiet is welcome. If I catch a fish or two it's a bonus.... Link to comment Share on other sites More sharing options...
Scifiman Posted December 12, 2016 Share #13 Posted December 12, 2016 Once I get her on the stand I should have a little room to work on her, thinking of upgrading the lights to LED, and have to figure out what I am going to do with this state of the art cassette deck. It would be nice to find an option where I can tie in a Bluetooth GPS, MP3 player that I can actually control from the audio controller, and still be able to use the intercom and CB. Only had the bike a few months so have not picked up the mics and headsets for the wired hookups as of yet. I have just started looking but so far I am a little surprised that some company hasn't jumped up with a nice all in one unit for the Ventures. That is the winter plan, we will see how it works out. SciFiMan Link to comment Share on other sites More sharing options...
uncledj Posted December 12, 2016 Share #14 Posted December 12, 2016 My Winter goal would be to not damage either of them (First Gen and Second Gen) as I squeeze between them to put salt in the softener. LOL During the Winter they live in the pump shed, where the softener also sits. I keep it at 45* in the Winter, and have a dehumidifier that runs when needed, so it's a great storage spot for the old gals. No room to work on them though. Link to comment Share on other sites More sharing options...
bj66 Posted December 12, 2016 Share #15 Posted December 12, 2016 My plans are to look at it sitting in my garage as I get in my truck on my way out to the ice shack. After the hectic fall that I had, piece and quiet is welcome. If I catch a fish or two it's a bonus.... I should proof read my posts a little closer.... While piece and quiet would be nice, I'm sure peace and quiet would be much more relaxing. I guess it shows that I liked history/government and biology more than I liked english and math in high school. I apologize to my high school teachers if I make them look bad. Link to comment Share on other sites More sharing options...
mraf Posted December 12, 2016 Share #16 Posted December 12, 2016 Rebuilding both front calipers. Plus upgrading the brake lines to stainless. I ty to spend a few hundred every year on the old girl so she knows she is not forgotten through another sunless, bleak winter. What Bob says. Link to comment Share on other sites More sharing options...
Flyinfool Posted December 12, 2016 Share #17 Posted December 12, 2016 Not a lot here Front and rear brake pads. Fork seals. come spring oil change. IF I get really ambitious, I still need to paint left saddlebag lid. Link to comment Share on other sites More sharing options...
ragtop69gs Posted December 13, 2016 Share #18 Posted December 13, 2016 I plan to fit a ski up front and a skinny track in place of the rear wheel and ride all winter. Sent from my SM-N920V using Tapatalk Link to comment Share on other sites More sharing options...
djh3 Posted December 13, 2016 Share #19 Posted December 13, 2016 Maybe put several hundred miles on it. Thinking late February I'll have to put some new rubber on it. Link to comment Share on other sites More sharing options...
BratmanXj Posted December 13, 2016 Share #20 Posted December 13, 2016 Whole front end teardown: New head bearings lower front forks (either new springs or slide them up, need to check funds) hardwire the Zumo GPS HID Headlight LED Spot Lamps Fix the "freeze plug" coolant leak and fix a slow leak in the Stratoliner front wheel RS Warrior is getting a new front tire But I ended up with a pile of garden tractors & snow throwers that people dropped up stuffed into my workshop that need attention before I can get to the bikes. Link to comment Share on other sites More sharing options...
cowpuc Posted December 13, 2016 Share #21 Posted December 13, 2016 Pat er on the fairing and stare at the stickers when I walk by her to crank up the Blower. Maybe Start er up every couple months, let er warm to temp and shut er off.. Link to comment Share on other sites More sharing options...
OrlinEngh Posted December 14, 2016 Author Share #22 Posted December 14, 2016 Here is a picture of my 86 that I want to take to some bike shows next summer, have some buffing on the engine and a little touch up. Wanted to do something a little different this summer and thought it may help with getting some business. Link to comment Share on other sites More sharing options...
OrlinEngh Posted December 14, 2016 Author Share #23 Posted December 14, 2016 Here is a couple of before and after pictures of the 83 still have the rims and engine to clean and buff out that's my winters work on this one, Amazing what replacing a few parts and adding a few can do. Link to comment Share on other sites More sharing options...
dusty roads Posted December 14, 2016 Share #24 Posted December 14, 2016 http://www.venturerider.org/forum/attachment.php?attachmentid=107923 Here is a picture of my 86 that I want to take to some bike shows next summer, have some buffing on the engine and a little touch up. Wanted to do something a little different this summer and thought it may help with getting some business. Now that's a beautiful 86. Mine is getting the full treatment, back to front and only needs everything. Did rear end of bike and now machining suspension items. Will never look as good as the 86 show bike but will hopefully run and handle perfectly. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now