kapebretoner Posted April 23, 2016 #1 Posted April 23, 2016 could somebody tell me how to replace the turn signal bulb in my top box. Bike is an 1989.
camos Posted April 23, 2016 #2 Posted April 23, 2016 The lens is glued to the base, mostly on the sides but sometimes a bit on the bottom. Using a utility knife, carefully cut in the slot between the lens and the base. It's quite brittle so don't pry just cut gently as many times as it take to release the lens. My lens is not attached between the signal lens and the rear lens. Use silicon seal to re-attach the lens.
cimmer Posted April 23, 2016 #3 Posted April 23, 2016 Make sure it is the light and not the switch on the trunk that is broken. I had it break on my 89. The best way to test it is to bypass the switch and see if the bulbs light that way. Rick F.
kapebretoner Posted April 24, 2016 Author #4 Posted April 24, 2016 thanks i will check the switch out.
videoarizona Posted April 25, 2016 #5 Posted April 25, 2016 Make sure it is the light and not the switch on the trunk that is broken. I had it break on my 89. The best way to test it is to bypass the switch and see if the bulbs light that way. Rick F. Yea... That was my problem as well....
camos Posted April 26, 2016 #6 Posted April 26, 2016 Make sure it is the light and not the switch on the trunk that is broken. I had it break on my 89. The best way to test it is to bypass the switch and see if the bulbs light that way. Rick F.Since there is no turn signal switch on the trunk, this answer would appear to address the trunk's interior light rather than the turn signal light referred to in the OP.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now