Flyinfool what are you up to now

[OrlinEngh]

Thunder storms and over 3 inch of rain last night the creeks are out of their banks:shock3: Is that snow machine of yours on the blink:think:

Or did you get that door shut good and tight up north:canada: to keep that cold air up there.

[cowpuc]

HOKEY SPAMOKEY OR:yikes:

You folks ok? That creek down in your campground where we stayed is not over the banks is it? Seemed like those were some really really high banks!!

That Fool said he was gonna try and rig up those Canadian doors so they were almost unopenable.. I wouldnt put it past him that he figured out a way to run a welder up there - been saying it for a long time now, that Fool is NO fool,, if anyone could close em permanently it would be HIM:guitarist 2:

[OrlinEngh]

We are good here just wet, the creek next to the campground is up out its banks, The Kickapoo River was at flood stage and coming up and we got a couple more inches this afternoon and more rain for tonight.

The campground will be fine most of the water goes away from it am lucky the valley gets wider where we are so there is more room for the water, I will have a little clean up but not much.

Fool must have done a good job on that door I don't see any real cold coming and not much for snow.

This flooding in December doesn't happen around here we usually have snow up to our knees or higher.

[Flyinfool]

Just think what 5 inches of rain would have looked like If I had not closed that door while I was up in the UP chasin deer.

 

The machine is just fine, Just I'm not OK.

 

Oh and don't tell @saddlebum that I used a special ceramic welding process. The welding rods are a mix of ceramic and unobtainium, Both are impervious to his plasma cutter that he likes to brag about..........

 

By the end of the week I will be on crutches for a couple months so I may not want to much snow. That is why I had to slam the door hard.

[saddlebum]

Just think what 5 inches of rain would have looked like If I had not closed that door while I was up in the UP chasin deer.

 

The machine is just fine, Just I'm not OK.

 

Oh and don't tell @saddlebum that I used a special ceramic welding process. The welding rods are a mix of ceramic and unobtainium, Both are impervious to his plasma cutter that he likes to brag about..........

 

By the end of the week I will be on crutches for a couple months so I may not want to much snow. That is why I had to slam the door hard.

My bosses overdid it at the truck auction and bought a rig they regretted. I am pretty sure that they would have no objections to me borrowing it to take down @Flyinfools puny little Royal Dalton door.