Need screws

[vicco27]

I need a couple of screws for the clutch and front brake master cylinders. I dropped one and can't find it. Need a replacement and could use a spare.

 

Thanks!

 

Keep the shiny side up.

[PGunn]

Those I believe are 5 mm screws as a temp fix try Home Depot they carry metric screws. Once you have the right one look on EBay for stainless ones to replace the Home Depot ones which will rust in time. You can coat the steel ones with light grease to hold off the rust over the short term

[cowpuc]

Ace Hardware carries a lot of em too..

[KeithR]

Clear nail polish is a good thing to keep away rust as well on the small screws.

[Wizard765]

I think Dingy might have them

[Rdfroese]

I changed my screws to hex head screws as they were badly scarred by past efforts to use a Phillips on a JIS (Japanese Industrial Standard) screw. I got a set of JIS screwdrivers now for all the other screws.

[BlueSky]

partszilla has some screws in stock if you can't get them locally.

[Flyinfool]

Yup, change them out to Hex socket head Stainless screws. Future life will be better. Most hardware stores will have them.

[cowpuc]

Ya know,, I always wondered why people gotta tighten those little suckers down so tight.. Yamaha spent all that time to make such cool little rubber gaskets and to do such a great job in designing the cover so the rubber gasket fits so nicely.. There really is no reason for those little screws to be put in with an impact driver .. I have ran all my Ventures with those screws loose enough that I can bump em out one handed and never had a leak problem... Same with the oil fill cap, seems like Magilla Gorilla was hired to put the oil fill cap on all my 1st Gens just before I get em.. Things got the most beautiful seal on it,, finger tight for thousands of miles and never an issue..

[vicco27]

Sending a big THANK YOU! to everyone out there who responded. Your replies were a big help.

[YamahaLarry]

Ya know,, I always wondered why people gotta tighten those little suckers down so tight.. Yamaha spent all that time to make such cool little rubber gaskets and to do such a great job in designing the cover so the rubber gasket fits so nicely.. There really is no reason for those little screws to be put in with an impact driver .. I have ran all my Ventures with those screws loose enough that I can bump em out one handed and never had a leak problem... Same with the oil fill cap, seems like Magilla Gorilla was hired to put the oil fill cap on all my 1st Gens just before I get em.. Things got the most beautiful seal on it,, finger tight for thousands of miles and never an issue..

 

So, are you saying not to put blue locktite on them?

[BlueSky]

Steel screws in aluminum tend to be very hard to remove. That is why I bought an impact driver very shortly after buying my first bike, a new 71 Honda CB350. An impact driver can get those screws loose without ruining them.