Rip Posted March 27, 2008 #1 Posted March 27, 2008 so ... the engine guard size must be larger than 1" diameter. I ordered a set of Kuryakan highway pegs...with 1 inch mounts. Now what? can I use them any way, and just tighten them down as far as they go?
SaltyDawg Posted March 28, 2008 #2 Posted March 28, 2008 The guards are 1 inch I would close the highway peg clamps and measure them to make sure they are actually the right size. I got a set a barons risers for my wifes mc that had one side 7/8th and the other one 1". You don't want them to be exactly 1" because then they won't tighten down enough to keep from moving. They should be about 1/16 of an inch smaller than the bars.
Pilot Posted March 28, 2008 #3 Posted March 28, 2008 Yup 1 inch check to see if you received the wrong ones, you might have the 7/8 inch size.
Rip Posted March 28, 2008 Author #4 Posted March 28, 2008 thanks for the replies--glad to know I didn't order the wrong size. When the clamps are closed the inside measurement on each one is 15/16's. I'll have to look at the engine guard again to see if maybe I was trying to put it on where there was a slight curve. I noticed there wasn't a great amount of option as to where to mount them. --Rip
SaltyDawg Posted March 28, 2008 #5 Posted March 28, 2008 Yeah you have to watch out for the curve and it does limit the placement of the clamps. Glad you got the right size.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now