Is This the Right part

[Chaharly]

Hey guys! I need to replace my carb intake manifolds because they are cracked. I believe i have found the part, but im stupid with part numbers and all of that, so is this correct?

 

4XY-13586-01-00 YAMAHA JOINT, CARBURETOR 1

[pbjman]

I think you'll need two of those and two of these (joint, carburetor 2)

4XY-13596-01-00 YAMAHA JOINT, CARBURETOR 2

[Yammer Dan]

The cracks won't leak. Paint them with liquid tape if the cracks bother you.

[ragtop69gs]

The cracks won't leak. Paint them with liquid tape if the cracks bother you.

 

Dans right, its rare that they leak. I spent the $ to replace mine under the assumption they were leaking. When I got them off I found none of the cracks were all the way through. They did look like they were.

 

Sent from my SAMSUNG-SGH-I997 using Tapatalk 2

[Condor]

The 1stGen joints have a metal sleeve sandwiched in the joint wall. The 2ndGens have a plastic liner on the inside of the joint except for that portion under the clamps. I replaced the '99's because joint cracks started to open up at the top when the clamps were tightened. In my mind they could cause a vacuum leak, so went ahead and replaced them for peace of mind...

[Chaharly]

I think you'll need two of those and two of these (joint, carburetor 2)

4XY-13596-01-00 YAMAHA JOINT, CARBURETOR 2

 

You're right the two on the right side. Think I'm going to replace all four of both.

 

I'm only replacing them because they are cracked all the way tthrough