Parts question

[darthandy]

I finally had time to install the rear caliper bracket that Eusa1 provided me but I'm missing a couple of washers. One is for the bolt that holds the bracket to the swingarm and the other goes between the swingarm and the bracket on the axle. My local dealer says that I can use appropriate size washers and that I don't need the actual Yamaha parts. This would be good as there is a two week back order on the washer for the axle.

 

So does anyone know the size of these washers (I.D , O.D.) or should I just go measure? I need to get this done quickly as the wife's car is in the driveway till I'm done in the garage. I guess you could say it's urgent. I wouldn't say that, but I know better than to say it out loud!

 

Thanks,

 

Andy