Stebel on 1st Gen - Mount and/or wires

[videoarizona]

I see there is a plug and play for 2nd gen offered for sale by a member, anyone make a similar unit for us 1st gen's?

TIA, david

[Flyinfool]

On the second gen everyone pretty much puts the horn in the same place.

On the first gen I don't know if I have seen any two bikes with the horns in the same places. This makes it hard to do a plug and play wire harness.

As far as mounting brackets, they will vary greatly depending on where you decide to put the new horn(s).

 

But then the wiring is so easy that even I could do it.

 

There are 2 wires that go to the stock horn. Just extend these 2 wires to reach your chosen location for the relay, these 2 wires connect to pins 85 and 86.

Run a wire from the battery Pos to a fuse, from the fuse to pin 30 on the relay, and from pin 87 to the + terminal of your new horn. Ground the other terminal of the horn and you are done.