Various braided stainless lines??

[WilCruise]

I've seen a few places that sell kits, but I'd like to get some stainless lines that aren't necessarily standard. Anyone know of a place that sells open stock of stainless lines of various sizes with banjo fittings (reasonably priced ideally) so I can make up my own set(s) or replace pieces as budget allows?

[Sweetnothing]

I have been told bu a lot of manufacturers they will not sell the lines to you because of the safety regulations of the fittings. I worked in a marine service department, and sometimes we had to replace lines. They won't sell the lines, nor will they put your fittings on a new line. What you have to do is find a place that has your fittings, and have them make the lines for you.

[Tartan Terror]

Greg,

All you have to do is go to JP cycles and they have everything you need. Just get the measurements and you can assemble anything you need

[sarges46]

I'm gonna guess that you checked out Ricks very nice cables at buckeyeperformance? He would probably also help you if you chose not to get the "whole" kit.

[WilCruise]

Rick,

Yes, I checked Rick's kits @ buckeye. They look good, but I want to do a piece here and a piece there and I'm going to do some mods.

 

Scotty,

That's what I was looking for, Guess I have to do the individual fittegs etc.

 

Anyone know if our banjos are 10mm or 12mm? I'm gueswsing 10 but not sure.

Thanks

[dray]

im not sure but i do know this guy sells lots of parts and SS lines for the 1100s you may give him a try you might get him to make what you need if he dont have it

 

 

http://www.metric-magic.com/

[CrazyHorse]

If it 1st Gen its 10mm x 1.25 if I remember right.

[Tartan Terror]

If it 1st Gen its 10mm x 1.25 if I remember right.

Yup! Thats it!