Fuel level sender needed

[winston66]

Winston 66.

From down under in Australia.

I was just wondering if there was anyone out there that could help me with a replacement ,Low fuel level sender that would suit my 1996 XVZ 13ATH Royal star.

I believe that the OEM part No is 4NK-85752-01-00 A working used one would be acceptable.

I did come across A used one on Pinwall cycles e bay site but the price was too high and when added to the shipping of US.$36.00, It was too much for me, A new one seems to be priced any where from $80.00 to $120.00 plus shipping

I have here a set of 4 carb. slider diaghprams . Keyster SD1 Marked Suzuki SSX7500/1100,

Yamaha XS1100 .I purchased these new from Sirius Concolidated last year but have found that they will not fit my smaller 28 mm carbs . They said that they were the correct ones .

They measure overall diameter of 72 mm with a hole for the slider of 29 mm. Rough measurements.

the fitment on my 28 mm carbs cover plate is about 63 to 65 mm. So these ones are no good to me They are still in their original unopened plastic packing and have been kept in the refrigerator since I received them.

Perhaps a swap or something could be arranged.

I would be happy to pay some reasonable amount for shipping etc.

 

If anyone is interested my email is meontop@hotmail.co.uk

 

Cheers to all,

Winston 66

[Condor]

Winston 66.

From down under in Australia.

I was just wondering if there was anyone out there that could help me with a replacement ,Low fuel level sender that would suit my 1996 XVZ 13ATH Royal star.

I believe that the OEM part No is 4NK-85752-01-00 A working used one would be acceptable.

I did come across A used one on Pinwall cycles e bay site but the price was too high and when added to the shipping of US.$36.00, It was too much for me, A new one seems to be priced any where from $80.00 to $120.00 plus shipping

I have here a set of 4 carb. slider diaghprams . Keyster SD1 Marked Suzuki SSX7500/1100,

Yamaha XS1100 .I purchased these new from Sirius Concolidated last year but have found that they will not fit my smaller 28 mm carbs . They said that they were the correct ones .

They measure overall diameter of 72 mm with a hole for the slider of 29 mm. Rough measurements.

the fitment on my 28 mm carbs cover plate is about 63 to 65 mm. So these ones are no good to me They are still in their original unopened plastic packing and have been kept in the refrigerator since I received them.

Perhaps a swap or something could be arranged.

I would be happy to pay some reasonable amount for shipping etc.

 

If anyone is interested my email is meontop@hotmail.co.uk

 

Cheers to all,

Winston 66

 

If your sender is a non-op, I think Freebird posted a repair thread, with pics, a few years back. You might contact him about it... I tried to find it without success. I do have a used post-ethanol sender for an RSV, but don't think it would fit your tank.