Jump to content

Recommended Posts

Posted

I am hearing a series of clicking noises from the rear of the bike when I turn the key on. Does the CLASS perform some function when the key is turned to on or does anyone have any guesses about this?

Posted

fuel pump

 

class only runs when the key is in the ACC position...and then you have to push the buttons...You can select "Auto" but that just shuts down the pump when the hi, med, or lo pressure has been achieved. It won't pump it up again unless you push the button

Posted

Clicking for a few seconds when you first turn the key on is a good thing. I always wait for it to finish clicking before I strt so that I know the float bowels are full.

 

It only clicks while moving fuel. so with the engine off it just clicks for a few seconds to top off the float bowels and then stops since there is no fuel flow.

 

On a 1st gen, most of the tank is below the carbs, so a pump is needed to bring up the fuel.

 

As mentioned the pump is a solenoid pushing a diaphragm back and forth hence the clicking as the solenoid cycles.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...