missing oil galley line?

[sandman]

pulled mtr and replaced orings that blow out aft of filter(main oil galley line to crankshaft). I,m ready to close it up and I notice a line missing that goes from flywheel resavor to oil pump area. cant find the line in fische for either vmax or venture engines. I know vmax has this line. Anyone familiar with this? Did ventures not use it? thanks

[Condor]

pulled mtr and replaced orings that blow out aft of filter(main oil galley line to crankshaft). I,m ready to close it up and I notice a line missing that goes from flywheel resavor to oil pump area. cant find the line in fische for either vmax or venture engines. I know vmax has this line. Anyone familiar with this? Did ventures not use it? thanks

 

Maybe since you can't find the line in the fische for either the V-Max or the Venture, and yet you have one on your V-Max, maybe it was added???

[sandman]

vmax pump is different than venture. I thought they were the same. It is a oil delivery line from flywheel resivor.

[dingy]

Vmax oil galley is different than Venture. There is another tube on VMax that Ventures don't have, goes into oil pump.

 

Some screen captures from Dameon Feruillo's VMax motor rebuild video.

 

Item 4, 5 & 6 in attached parts fiche cut. Oil pump section, this was from a 2004 fiche.

 

Gary

[sandman]

There is more differences in the two motors than one would think. Not sure of lines actual benifit.

[dingy]

Attached are the lubrication charts for MKII Venture & VMax.

 

VMax chart is more detailed.

 

Gary

[Big Lou]

I just finished mine 2 months ago

I looked all over the shop , blamed the dog, talked to myself for laying it down away from the rest of those parts on the table ,,

 

then I remembered it didnt come that way and it was running good

 

book sure had me fooled

 

runs fine ,, I am kind of wondering if I went to find one will it do any good,,

and will it mount,,

[sandman]

Big lou; you would need a vmax pump. and it appears to be a return line from flywheel area, to pump. I also want to thank everyone for the prompt replies. It helps when your wanting to get bike done. also thanks Gary for all your time. sandy