Removing anti tamper covers

[playboy]

Can someone tell me where the anti tamper covers for the air adjustment are located or post a pic of them. Been looking in the service and parts manuals but they must be under a different name or terminology for me to find them. And what is the best way to remove them when I find them.

 

[wrenchrob]

anti-tamper covers????????:confused24:

[playboy]

On the carbs Rob

[wrenchrob]

AHHHHHH! Those anti-tamper covers.

[djh3]

I have seen a pic of them and will try to remember where. Not sure how much room youll have to play with but there is a couple different ways we use to take them out. Small pin punch, punch in top and pop out. Small sheet metal type screw into top and pull them out. Spring loaded center punch, (theres another name for it but danged if I can remember right now) pop center a couple times and usualy it deform enough to get them out. These what your talking about on the pilot screws? http://venturers.org/Tech_Library/attachments/Pilot_Screws_3.jpg

[Beau-Kat]

Note that these carbs are shown upside down.

Although not shown in this photo, the caps are kind of "cone head" shaped.

When I went through my carbs last week, I just used pliars to remove them by pulling straight out on them.

I cleaned the pilot screws and ports, adjusted to 2 & 1/4 turns out, then tapped the caps back into place, just to keep things clean. Most folks probably don't replace the caps.

 

http://www.google.com/imgres?q=rsv+pilot+screw+caps&um=1&hl=en&sa=N&biw=1060&bih=602&tbm=isch&tbnid=c8Ja3IwSWi_-IM:&imgrefurl=http://www.venturers.org/Tech_Library/index.php%3Faction%3Darticle%26cat_id%3D002010%26id%3D168&docid=zpWi1vw7331OBM&imgurl=http://venturers.org/Tech_Library/attachments/Pilot_Screws_1.jpg&w=600&h=450&ei=odomULKgIen00gGzuIDoDA&zoom=1

[playboy]

Thanks guys