Needin' 1st gen rear turn signal pieces.

[Snaggletooth]

Ok, before I hit the fleaBay curcuit again I know some of you are parting out some 1st gens.

 

I find myself in need of at least one, if not both of the jointed mounting studs that tie the signal housings to the fender stays.

 

I don't need the entire signal body, just the long angled stud that runs through it with the rubber joint and the short stud to the stay. But if the price is right for the whole assembly that will do to.

 

Found why mine started wiggling so bad. The rubbers joints are breaking up.

 

Let me know,

 

Thanks,

 

Mike

Edited July 17, 2012 by Snaggletooth

[friesman]

Found why mine started wiggling so bad.

 

Let me know,

 

Thanks,

 

Mike

 

 

ITs just because youre getting older......

 

Brian

[Snaggletooth]

I worry less about the wiggle than when it won't bend at all.

 

Da' Snagglestud

[Snaggletooth]

I was able to grab a set off fleaBay for under $20.00. Should cover my parts needs.

 

Thanks anyway.

 

Mike